Car steering Hyundai Accent 2

General information about steering
The steering system consists of a steering wheel, a steering column, a steering rack and a steering rod. The steering wheel is fixed to the steering column shaft and...

Technical data of steering
Steering Steering without power assistance Steering shaft Disassemblable with two hinged joints Transmission stroke, mm 134 Turning the steering wheel from lock to lock...

Steering column/steering shaft
1 – bolt, 15–20 Nm; 2 – intermediate shaft with universal joints; 3 – bolt, 15–20 Nm; 4 – bolt, 4–6 Nm; 5 – protective cover; 6 – steering column; 7 – clamp. Removal 1....

Steering column tilt adjustment mechanism
Execution order 1. Install the universal joint onto the steering gear shaft. Warning: If the steering column is equipped with a tilt adjustment mechanism, observe the...

Steering gear without power steering
1 – steering rod end; 2 – clamp; 3 – corrugated protective cover; 4 – clamp; 5 – lock nut, 50–70 Nm; 6 – cork; 7 – spring; 8 – emphasis; 9 – rubber support; 10 –...

Steering rod — removal and installation
1 – steering rod; 2 – steel clamp; 3 – protective cover; 4 – nut, 16–34 N·m; 5 – steering rod end; 6 – clamp. Removal Remove the steering gear, pinion and tie rods from...

Checking the steering wheel play on cars with power steering
Execution order 1. Start the engine with the steering wheel set to the straight-ahead position. With the front wheels set to straight-ahead, measure the effort required...

Checking the front wheel steering angle
Execution order 1. Turn the front wheels of the car to the maximum angle and measure the turning angle of each wheel. Rotation angle: Inner wheel: 37°37' ±1°30' Outer...

Checking the torque of the ball joint of the steering rod end
Execution order 1. Screw two nuts onto the ball joint journal of the tie rod end and measure the torque required to turn the ball joint journal. Torque required to...

Checking the steering wheel turning force on vehicles with power steering
Execution order 1. With the vehicle on a firm, level surface, set the front wheels to straight ahead. 2. Increase engine speed to 1000 min⁻¹. Warning! After checking,...

Checking the return of the steering wheel to its original position
Check that the steering wheel returns to its original position. Execution order 1. The force required to turn the steering wheel and return the wheel to its original...

Checking the fluid level
Warning: Only add recommended fluid to the power steering hydraulic system. Execution order 1. Place the vehicle on a level, horizontal surface. 2. Start the engine and...

Replacing the fluid in the hydraulic power steering drive
Execution order 1. Raise the front of the vehicle and support it on jack stands. 2. Disconnect the return hose from the tank. 3. Connect the additional hose to the...

Bleeding the hydraulic power steering system
Execution order 1. Disconnect the high-voltage wire from the ignition coil. Periodically turn on the starter for 15-20 seconds and at the same time turn the steering...

Checking the tension of the power steering pump drive belt
Execution order 1. Check the belt tension by applying 98 N (10 kg) of pressure to a point equidistant from the pulleys and measure the belt deflection. Belt deflection:...

Checking the fluid pressure in the hydraulic system
Execution order 1. Disconnect the pressure hose from the power steering pump. Connect the special measuring tool between the disconnected pressure hose and the pump as...

Steering gear for vehicles with power steering
1 – tie rod end locknut, 50–55 Nm; 2 – clamp; 3 – protective cover; 4 – clamp; 5 – steering rod, 80–100 Nm; 6 – lock washer; 7 – lock nut, 50–70 Nm; 8 – cork; 9 –...

Power steering hoses
1 – return hose; 2 – tank; 3 – suction hose; 4 – pressure hose. Removal the return hose 1. Drain the fluid from the power steering hydraulic drive. 2. Disconnect the...

Power steering pump
1 – bolt, 55–60 Nm; 2 - O-ring round section; 3 – bolt, 16 Nm; 4 – suction pipe; 5 – liquid pressure sensor; 6 – pulley; 7 – retaining ring; 8 – spacer sleeve; 9 – shaft...

Troubleshooting (Non-Power Steering)
Sign Probable cause Method of elimination Increased steering wheel free play The steering gear is not securely fastened Tighten it up Steering gear bolts not tightened...

Troubleshooting (power steering)
Sign Probable cause Method of elimination Increased steering wheel free play The steering gear is not securely fastened Tighten it up Steering gear bolts not tightened...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

We recommend other sections on the topic of Hyundai manuals:

Chassis: Steering Hyundai Elantra 1 (1990-1995, petrol)
Chassis: Steering Hyundai Getz (2002-2011)
Chassis: Steering Hyundai Sonata 4 (2001-2012, petrol)
Chassis: Steering Hyundai Santa Fe 2 (2007-2012, petrol)
Chassis: Steering Hyundai Tucson 1 (2005-2010)
Chassis: Steering Hyundai Matrix (2001-2010, petrol)

Add to social network:

Link in different formats to this section

TextHTMLBB Code