Electrical equipment and appliances Hyundai Accent 2

General information about electrical equipment
The negative ground electrical system has an operating voltage of 12 volts. Power for the electrical system comes from a lead-acid battery, which is recharged by the...

Technical data of electrical equipment
Battery Type MF 45 Ah MF 55 Ah Amp hours (5HR) More than 36 Ah More than 44 Ah Amp hours (20HR) More than 45 Ah More than 55 Ah Current strength when turning the...

Electrical circuits — fault detection
Execution order 1. A typical electrical circuit consists of electrical components, switches, relays, motors, fuses, fuse links, and the wires and connectors that connect...

Radio receiver — removal and installation
Removal 1. Disconnect the cable from the negative battery terminal. 2. Remove the glove box. 3. Disconnect the heater control circuit wires under the glove box and from...

Front and rear speakers
Front speakers 1. Remove the front door trim, unscrew the screws and remove the speaker. 2. Installation is carried out in the reverse order of removal. Rear speakers 1....

Antenna — removal and installation
Removal 1. Disconnect the cable from the negative battery terminal. 2. Remove the rear cross trim and trim from the left rear side of the trunk. 3. Unscrew the antenna...

Multifunction switch — removal and installation
Removal and installation Cars without airbags 1. Remove the horn button and steering wheel. 2. Remove the upper and lower steering column covers. 3. Remove the screws...

Sound signal — removal and installation
Execution order 1. Remove the bolt and remove the horn. 2. Installation is carried out in the reverse order of removal. Adjustment If necessary, adjust the tone by...

Fuses — Description and Replacement
Fuses are designed to break the circuit when the current reaches a certain value, in order to protect elements and wires that could be damaged by too much current. A...

Instrument cluster — removal and installation
Removal 1. Disconnect the cable from the negative battery terminal. 2. Remove the instrument cluster cover. 3. Remove the screws and remove the instrument cluster....

Windshield wiper motor
Removal 1. Loosen the nuts and remove the windshield wiper arms. 2. Remove the cover located under the windshield. 3. Remove the wiper motor. 4. Remove the bolts and...

Replacing the headlight and front turn signal
Execution order 1. Disconnect the cable from the negative battery terminal. 2. Remove the holder in the bumper cover. 3. Remove the bolts and remove the headlight. 4....

Headlight adjustment
The headlight beam must be adjusted using special equipment and in accordance with the equipment manufacturer's instructions. Rotate the adjusting wheels alternately to...

ABS Electrical Wiring Diagram
ABS Electrical Wiring Diagram

Electrical diagram of the charging system
Electrical diagram of the charging system

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

We recommend other sections on the topic of Hyundai manuals:

Electrical equipment: Equipment and devices Hyundai Elantra 2 (1995-2000, petrol)
Electrical equipment: Equipment and devices Hyundai Getz (2002-2011)
Electrical equipment: Equipment and devices Hyundai Sonata 3 (1993-1998)
Electrical equipment: Equipment and devices Hyundai Santa Fe 2 (2007-2012, petrol)
Electrical equipment: Equipment and devices Hyundai Tucson 1 (2005-2010)
Electrical equipment: Equipment and devices Hyundai Matrix (2001-2010, petrol)

Add to social network:

Link in different formats to this section

TextHTMLBB Code