Exterior (external elements) of the car Hyundai Accent 2
Body technical data Windscreen thickness, mm 5 Front window glass thickness, mm 3,2 Thickness of back window glass, mm 3,2 Thickness of rear fixed glass, mm 3,2 Thickness of rear fixed...
Hood hinge adjustment 1. Loosen the hood hinge bolt. 2. When moving the hood, adjust its position so that when the hood is closed, the gap around the hood perimeter is the same on all sides....
Trunk lid — removal and installation Warning! Remove the trunk lid with an assistant. Withdrawal 1. Turn out bolts of fastening of the hinge of a cover of a luggage carrier and remove a cover of a luggage...
Tailgate Adjustment Order of execution 1. Adjust the position of the strike plate by moving it down or to the right or left so that the rear of the door is flush with the adjacent surfaces....
Front door — removal and installation Removal and installation 1. Release the power window handle bracket and remove the handle. The bracket is released by inserting a clean cloth between the handle and the...
Rear door — removal and installation Withdrawal 1. Release the power window handle bracket and remove the handle. The bracket is released by inserting a clean cloth between the handle and the door...
Moldings — removal and installation 1 - roof molding; 2 - door moldings. Removal and installation Door molding Using special tool 09800-21000, starting at either end of the molding, separate it from the...
Sunroof — removal and installation 1 - a gasket that aligns the upper part of the hatch with glass; 2 - hatch trim with glass; 3 – hatch hinge; 4 - moisture-proof seal; 5 - glass panel of the hatch; 6 -...
Outside rear view mirror 1 - body; 2 - electric mirror drive; 3 - mirror glass; 4 - body; 5 - mirror glass. Withdrawal Warning! Wear gloves to prevent injury to your hands when removing the...
Windshield — removal and installation 1 – the spacer plug of a windshield; 2 – windshield molding; 3 – an internal rear-view mirror; 4 - windshield; 5 - windshield lining. Withdrawal 1. Before removing the...
Rear glass — removal and installation 1 - rear window molding; 2 – a lining of back glass; 3 – the top molding of back glass; 4 – back glass; 5 – the bottom lining of back glass; 6 - rear window molding; 7 –...
Front bumper — removal and installation 1 - bumper pad; 2 - energy absorber; 3 - bumper amplifier. Withdrawal 1. Remove the bracket. 2. Remove headlight. 3. Remove the holders and turn out the nuts of the...
Rear bumper — removal and installation 1 - bumper pad; 2 - energy absorber; 3 - bumper amplifier. Withdrawal 1. Remove a back cross upholstery and an upholstery of a back part of a luggage carrier. 2. Remove...
Troubleshooting sign Probable Cause Elimination Method Wind noise around the door Waterproof film not securely attached Attach the waterproof film securely Waterproof film not properly...