Exterior (external elements) of the car Hyundai Santa Fe 2
Removal and installation of the wing Withdrawal Pic. 8.1. Removing the wing protector Remove the screws holding the inner wing protector, and then remove the protector (pic. 8.1). Pic. 8.2. Removing the...
Hood adjustment Adjust the longitudinal and transverse position of the hood using the elongated holes in the hinge. Pic. 8.4. Hood adjustment screws Turn the hood lugs counterclockwise...
Removal and installation of a back door Withdrawal Pic. 8.6. Removing an additional brake light Remove the center top brake light (pic. 8.6). Pic. 8.7. Removing the top trim Remove the rear door frame trim...
Removal and installation of front door components Withdrawal Pic. 8.11. Screw holding the inner upholstery of the door handle Loosen the screw holding the inner door handle trim (pic. 8.11). Pic. 8.12. Screws holding...
Door position adjustment Check that the door is flush with the body, then check that the gaps between the front and rear, the top and bottom edges of the door and the body are equal. The door...
Door lock latch adjustment Make sure the door fasteners are tight and that it closes securely. If necessary, adjust the door as follows Draw a line around the lock latch. Pic. 8.20. Lock retainer...
Tailgate adjustment Check that the door is flush with the body, then check that the gaps between the front and rear, the top and bottom edges of the door and the body are equal. The door...
Adjustment of a latch of the lock of a back door Make sure the door fasteners are tight and that it closes securely. If necessary, adjust the door as follows Draw a line around the lock latch. Pic. 8.28. Screws of...
Removal and installation of a lateral overlay of a roof Pic. 8.29. Removing the side roof lining Remove the roof side trim using a flat blade screwdriver (pic. 8.29). Attention! When using a flat blade screwdriver, wrap it...
Removal and installation of the sunroof Withdrawal To remove the sunroof, first remove the following items: ceiling lamp; sun shield and handrail; stand upholstery. Pic. 8.30. Glass panel mounting nuts Remove...
Checking the operating mode after installation If the glass panel moves slowly, check and adjust. Make sure the battery is fully charged. Make sure no abrasive materials get into the sunroof sliding module. Make sure...
Sunroof adjustment Adjust the height difference between the glass panel and the roof panel. Front: 0 (+0,0; –1,0) mm. Back side: 0 (+1; +0) mm. If the height difference is abnormal, adjust...
Removal and installation of an external rear-view mirror Withdrawal Pic. 8.34. Installing a screwdriver Install a flat-blade screwdriver between the door mirror holder and the mirror unit (pic. 8.34). Attention! Use gloves...
Removal and installation of a forward bumper Withdrawal Disconnect the leads to the turn signals and headlights. Remove the turn signal and headlight bulbs. Pic. 8.36. Front bumper screws Loosen the screws holding...
Removal and installation of a back bumper Withdrawal Pic. 8.39. Screws of fastening of a cover of a back bumper Loosen the rear bumper cover screws (pic. 8.39). With the vehicle raised, remove the screws holding...