Vehicle power equipment Hyundai Santa Fe 2

General information about the charging system
The charging system consists of a battery, a generator with a built-in voltage regulator, a battery discharge indicator lamp, and wiring. The generator has a rectifier...

Checking the generator output voltage drop (2.4L)
This test is necessary to assess the condition of the wiring from the generator terminal "B" to the (+) terminal of the battery (including the fuse link). Preparing for...

Checking the generator output current (2.4 l)
This test determines whether the generator output current matches the rated value. Preparing for the test Before starting the test, perform the following checks and...

Checking the voltage regulator (2.4L)
This test determines if the electronic voltage regulator is properly controlling the generator output voltage. Preparing for the test Before starting the test, please...

Checking the generator output voltage drop (2.7L)
This test is necessary to assess the condition of the wiring from the generator terminal "B" to the (+) terminal of the battery (including the fuse link). Before...

Checking the generator output current (2.7 l)
This test determines whether the generator output current matches the rated value. Before performing a test, always check the following: installation of the generator...

Checking the voltage regulator (2.7L)
This test determines if the generator voltage regulator is properly controlling the generator output voltage. Before you start, check: installation of the generator and...

Disassembly, inspection and assembly of the generator (2.4 l)
Fig. 7.24. Generator mounting Fig. 7.25. Generator components Disassembly Loosen the four tie bolts. Insert a flat-blade screwdriver between the front generator bracket...

Disassembly, inspection and assembly of the generator (2.7 l)
Loosen the four tie bolts. Insert a flat-blade screwdriver between the front generator bracket and the stator and, using the screwdriver as a lever, pry (down) the front...

Battery pack-Load test
When the battery is discharged for 15 seconds with a current equal to half the value of the output current during a cold start, the voltage at the battery terminals...

Visual inspection of the battery
Turn the ignition key to the "OFF" position and turn off all additional electrical equipment. Fig. 7.48. Disconnecting the wire from the battery terminal Disconnect the...

General information about the engine starting system
Fig. 7.49. Starter The engine starting system consists of a battery, starter, traction relay, ignition switch, starter interlock switch (automatic transmission models...

Starter — checking and adjustment
Fig. 7.53. Starter mounting Adjusting the axial clearance of the drive gear Disconnect the stator winding wire from the "M" terminal of the traction relay. Fig. 7.54....

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

We recommend other sections on the topic of Hyundai manuals:

Electrical equipment: Power devices Hyundai Accent 2 (1999-2005)
Electrical equipment: Power devices Hyundai Elantra 3 (2000-2006)
Electrical equipment: Power devices Hyundai Getz (2002-2011)
Electrical equipment: Power devices Hyundai Matrix (2001-2010, petrol)

Add to social network:

Link in different formats to this section

TextHTMLBB Code

Santa Fe 2 (2007-2012, petrol)