Engine cooling and lubrication system Hyundai Accent 3
Cooling system Note: the figure shows the elements of the 1.6 liter engine cooling system. The 1.4 liter engine cooling system is structurally different only in the inlet and outlet...
Removal and installation of the coolant pump Withdrawal 1. Drain the coolant. 2. Loosen the coolant pump pulley screws. Tightening torque: 8-10 Nm 3. Remove drive belts. 4. Remove the coolant pump pulley. 5. Remove...
Removal and installation of the thermostat Withdrawal 1. Drain the coolant so that its level is below the thermostat. 2. Remove the inlet (1), gasket (2) and thermostat (3). Tightening torque: 15-20 Nm. Note:...
Removal and installation of a radiator Note: for different configurations and markets, the location and number of fans may differ from those shown. 1. Expansion tank 2. Radiator 3. Radiator support bracket 4....
Radiator and electric fan check Radiator cap check 1. Remove the radiator cap, apply coolant to the oil seal, and install the cap on the pressure tester. 2. Pressurize 93.16-122.58 kPa and check for...
Lubrication system 1. Front crankcase cover 2. Oil filter 3. Gasket 4. Oil receiver 5. Drain plug 6. O-ring 7. Oil pan
Removal and installation of the oil pump 1. Front crankcase cover 2. Oil seal 3. Bypass valve plunger 4. Inner rotor 5. Spring 6. Outer rotor 7. Cork 8. Oil filter 9. Oil pump cover 10. Gasket Withdrawal 1....
Checking pump parts 1. Check the ease of rotation of the oil pump rotors and the absence of cracks in the housing. 2. Using a set of feeler gauges and a metal ruler, measure the clearance...