Ignition, charge and engine start system Hyundai Accent 3

Removal and installation the ignition coil
Removal 1. Remove the engine cover. For 1.4L engines only 2. Disconnect the connector and high-voltage wires from the ignition coil. 3. Remove the ignition coil (1). For...

Checking the ignition coil
1. Using a spark plug wrench, remove the spark plug. 2. Connect the spark plug lead to the spark plug (1.4L engine) or insert the spark plug into the ignition coil (1.6L...

Checking the generator output voltage drop
Note: This test is necessary to assess the condition of the wiring from the generator terminal "B" to the positive terminal of the battery. 1. Turn off the ignition (key...

Checking the generator output current
Note: This test is necessary to determine the magnitude of the generator output current and its compliance with the nominal value. 1. Check the installation of the...

Checking the regulated voltage
Note: This test is performed to determine the condition of the voltage regulator. 1. Check the battery charge (the battery must be fully charged) and the tension of the...

Removal and installation the generator
Removal 1. Disconnect the cable from the negative terminal of the battery, and then from the positive terminal. 2. Remove the accessory drive belts. 3. Disconnect the...

Disassembly and assembly of the generator
1. Nut 2. Pulley 3. Bushing 4. Front cover 5. Front bearing 6. Thrust plate 7. Screw 8. Rotor 9. Rear bearing 10. Bearing cover 11. Back cover 12. Screw 13. Seal 14....

Checking generator units
Rotor 1. Use an ohmmeter to check the circuit between the rotor slip rings (1). If the circuit is open, replace the rotor. 2. Check the circuit between the slip rings...

Checking the battery
1. Connect the load tester to the battery terminals. Note: If the battery was charged before testing, remove the static charge by connecting a load plug (300 A) for 15...

Checking the starter solenoid relay
1. Disconnect the excitation winding wire from the "M" terminal of the traction relay. 2. Connect the battery between the "S" terminal and the starter housing. Note: The...

Checking the starter operation without load
1. Clamp the starter in a vice and connect a fully charged battery. 2. Connect the ammeter (with a measurement limit of 100 A) and rheostat in the indicated manner. 3....

Removal and installation the starter
Removal 1. Disconnect the wire from the negative terminal of the battery. 2. Remove the air filter. 3. On models with manual transmission, remove the gear selection and...

Disassembling and assembling the starter
1. Screw 2. Front bracket 3. Retaining ring 4. Thrust ring 5. Drive gear with overrunning clutch 6. Fork 7. Gasket 8. Pull-in relay 9. Anchor 10. Starter housing 11....

Checking starter components
Collector 1. Check the anchor surface for damage and wear. If there is damage or wear, replace the anchor. 2. Check the surface of the commutator (1). If carbon deposits...

Checking the starter relay
1. Remove the fuse box cover and take out the starter relay (14). 2. Use an ohmmeter to check the integrity of the relay circuit: contacts 30 and 87 - the circuit is...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

We recommend other sections on the topic of Hyundai manuals:

Power unit: Engine electrical equipment Hyundai Sonata 4 (2001-2012, petrol)
Power unit: Engine electrical equipment Hyundai Tucson 2 (2009-2015)

Add to social network:

Link in different formats to this section

TextHTMLBB Code