Contents: Removal ⇓ Installation ⇓
Removal
1. Disconnect the cable from the negative terminal of the battery, and then from the positive terminal.
2. Remove the accessory drive belts.
3. Disconnect the connector (1) and the terminal "B" wire (2) from the generator.
4. Unscrew the adjusting screw (3) and the fastening screw (4). Remove the generator tension bar (5). Unscrew the lower screw (6) and remove the generator (7).
Installation
5. Installation is carried out in reverse order.
The article is copied from this website (HYUNDAIBOOK.ru)
6 Adjust the tension of the drive belts.
