1. Nut
2. Pulley
3. Sleeve
4. Front cover
5. Front bearing
6. Thrust plate
7. Screw
8. Rotor
9. Rear bearing
10. Bearing cap
11. Back cover
12. Screw
13. Oil seal
14. Block of rectifier diodes
15. Hairpin
16. Brush holder
17. Screw
18. Slip ring guide
19. Lid
Generator disassembly
1. Loosen the nuts and remove the voltage regulator cover (1) with a screwdriver (2).
2. Loosen the screws (3) and remove the brush holder (4).
3. Remove the slip ring guide (5).
4. Using a wrench, unscrew the nut and remove the pulley (6).
Note: Desolder the 3 stator winding leads if necessary.
5. Remove 4 bolts (7).
6. Remove covers (8) and remove the rotor (9).
Assembly
7. Assembly is carried out in reverse order.