Description of the device and steps for repairing the front and rear suspension of the first generation Hyundai Accent, which were produced from 1994 to 1999.
Specifications of the front suspension Suspension type - Candlestick, on MacPherson struts with a coil spring Shock absorber - Hydraulic, double-acting Maximum length - 470 mm Collapsed length - 319 mm Travel...
Front suspension problems Possible malfunctions of the front suspension, their causes and solutions.
Installing the front wheels Park the vehicle on a level surface with the wheels in a straight line. Wheel toe-in Convergence (B-A or corner) adjustable by turning the tie rods. Convergence (B-A) mm...
Checking the ball joints of the front suspension 1. Remove the ball joint assembly from the lower arm. 2. Check ball joints for rotation. 1) As shown in the figure, rock the ball joint shaft in the groove 5 times....
Ball joint and dust cover replacement 1. Remove the dust cover from the lower arm ball joint using a screwdriver. 2. Remove the snap ring. 3. Using the special tool, remove the ball joint from the lower arm....
Rear Suspension Specifications Suspension type - double wishbone Helical spring: wire diameter x outer diameter x height without load - 10.7 x 110.7 x 315 mm Shock absorber: type — Hydraulic...
Checking the axial clearance of the rear wheel bearing 1. Jack up the car. While the machine is on the floor jack» check bearing clearance. 2. If there is play, remove the hub cap and then release the parking brake. 3....
Rear suspension — removal, inspection and installation Withdrawal 1. Remove the top rack nuts. 2. Remove the brake caliper. 3. Remove the brake disc. 4. Remove the brake hose pinch bolt. 5. Remove the end of the parking...