Car Owner's Manual Hyundai Accent 3

Driver's workplace
1. Hood lock lever 2. Front and rear fog light switch 3. Headlight beam position regulator 4. Instrument cluster 5. Combined outdoor lighting switch 6. Driver's...

Instrument cluster, type A
Instrument cluster, type A. Light and digital indicators. Analogue gauges 1. Tachometer 2. Direction indicator light 3. Door open indicator light 4. Front passenger...

Instrument cluster, type B
Instrument cluster, type B. Light and digital indicators. Analogue gauges 1. Tachometer 2. Direction indicator light 3. Engine oil pressure indicator light 4. Digital...

Control and signal indicators
Turn signal indicator light. Flashing green arrows on the instrument panel show the direction the turn signals are pointing. If the arrows light up but do not flash or...

On-board computer (optional)
An on-board computer is a device that displays a number of parameters on the screen (outside air temperature, mileage, travel time, fuel consumption, average speed and...

Coolant temperature gauge (instrument cluster type A)
Make sure that the pointer is always between the C ("Cold") and H ("Hot") marks. If the pointer exceeds the H mark, stop the car immediately and turn off the engine....

Speedometer
The instrument arrow indicates the vehicle's speed in kilometers per hour (km/h).

Tachometer
The instrument needle indicates the engine crankshaft speed in revolutions per minute (rpm). Try to avoid running the engine at high speeds (needle in the red zone)....

Odometer
The odometer shows the total mileage of the vehicle and is also used to ensure periodic maintenance.

Trip odometer
After pressing the TRIP button with the ignition on, two trip odometers are displayed. Switching between TRIP A and TRIP B modes is done by pressing the TRIP button....

Car keys
The car comes with three keys. Two "master keys" and one "service key". The "master key" can open all the car's locks. The "service key" can only open the door locks and...

Immobilizer (optional)
Immobilizer is an anti-theft device. The "master key" can be used to open all the car's locks. The key has the M symbol on one side. The "service key" allows you to open...

Key positions in the ignition switch
START position: in this position the engine starts. ON position: In this position, the ignition is turned on. Power is supplied to all devices. To avoid discharging the...

Removal the key from the ignition switch
Set the key to the ACC position. Press the key, set it to the LOCK position and remove it from the ignition switch

Engine start. Ignition switch illumination
Starting the engine If the vehicle is equipped with a manual transmission (hereinafter referred to as MT), set the gearshift lever to neutral and fully depress the...

Turn signal switch
When the switch lever is moved downwards from the middle position, the left turn signals are turned on, and when the lever is moved upwards, the right turn signals are...

Headlight switch
To change the headlight mode, turn the tip of the switch handle. In the first position, the sidelights, rear sidelights and instrument panel lighting are switched on. In...

Automatic switching off of parking lights (optional)
If the parking lights remain on after the end of the journey, they will automatically turn off when the doors are opened. To turn on the parking lights, simply set the...

Daytime running lights (optional)
Your Hyundai is equipped with daytime running lights. The running lights are on whenever the engine is running. This also applies when the exterior lighting switch is in...

Headlight high beam switch
To turn on the high beam headlights, move the switch lever away from you. The high beam indicator should light.

High beam headlight signaling
To briefly turn on the high beam, pull the switch lever toward you (to the non-locking position) from the low beam position. The high beam signal also functions when the...

Windscreen wiper and washer switch
The windshield wiper switch has three fixed positions. 1. Intermittent operation mode (INT). 2. Continuous operation, low speed (LOW). 3. Continuous operation, high...

Adjusting the operation of the brushes
Turning on brushes for one stroke To turn on the brushes for one stroke, pull the switch lever up. Adjusting the operation of brushes in intermittent mode To activate...

Rear window wiper and washer (optional)
In this position of the drum switch, the washing fluid is supplied to the rear window, and the windshield wiper is switched on for three strokes (On) In this position of...

Fog light switch
Front fog light switch (optional) The front fog lights are switched on by pressing the top button. They will function when the headlight switch is set to the second...

Manual transmission
The manual transmission has a classic gear shift pattern. The pattern is shown on the gear shift knob. The gearbox is fully synchronized. Before engaging reverse gear,...

Automatic transmission
The automatic transmission has four forward and one reverse speed. When changing gears, depending on the selected range, you must either press the brake pedal...

Parking brake
Always apply the parking brake before leaving the vehicle. When the ignition is on, the parking brake indicator light warns you that the parking brake is on. To engage...

Interior lighting
Directional lighting lamps (optional) To turn on the directional individual lighting, press the switch. Interior light In the "DOOR" position, the light turns on when...

Heating and ventilation system
1. Side upper air deflectors 2. Side air deflectors 3. Windshield deflector 4. Central air deflectors

Central and side air deflectors
To change the direction of the air flow, turn the handle under the deflector in the right direction. In position the deflector is open. In position the deflector is...

Heating and ventilation system control
1. Temperature controller 2. Air conditioner switch 3. Air flow mode regulator 4. Air flow regulator 5. Fan speed controller Temperature controller The regulator allows...

Air flow mode switch
This switch (two keys) allows you to switch between the mode of fresh air supply from outside the car and the air recirculation in the passenger compartment.

Air flow regulator
The regulator allows you to change the direction of the air flow. Air flow distribution modes "Maximum air conditioner level" mode (optional) (MAX A/C) Air is supplied...

Heating system control
In normal operation, the air inlet mode regulator is set to the fresh air supply position, and the air flow regulator is set to the floor position. For quick heating,...

Two-level air supply
This mode allows you to supply cool air from the dashboard vents and warm air at floor level at the same time. Set the air intake mode control to the "fresh air"...

Interior ventilation
To turn on ventilation, set the air flow mode regulator to the "fresh air" position. To supply air only through the dashboard deflectors, set it to the "face level"...

Removal fog from the inside of glass
To remove fogging, set the air inlet mode regulator to the outside air supply position and the air flow regulator to the "heating" position. Set the fan speed and air...

Removal fog from outside glass
To remove fog, set the air intake mode control to the outside air position, and the air flow control to the "heat" position. Set the speed control to position 3 or 4,...

Air conditioning (optional)
Air conditioner switch The air conditioner is turned on by pressing the "A/C" switch on the system control panel. Air cooling Turn on the fan. Turn on the air...

Automatic control system for heating and ventilation of the passenger compartment (optional)
1. Temperature controller 2. Air conditioner switch 3. Air flow mode switch 4. Heater switch 5. Fan speed controller 6. Automatic mode switch (AUTO) 7. Display 8. Air...

Air supply control switch
To select between air supply from outside the car or air circulation in the cabin, press the corresponding button. When the mode is turned on, the indicator light should...

Cabin ventilation system filter (optional)
The filter is located in the fan intake pipe behind the glove compartment. It is designed to clean the air that is supplied to the cabin. 1. Air into the cabin 2. Filter...

Glasses compartment (optional)
The glasses compartment is located in the front overhead console. To open the lid, press its edge.

Glove box
The storage compartment is located in the front panel of the passenger compartment in front of the front passenger.

Exterior rear view mirrors
The position of the exterior rear-view mirrors is adjusted from inside the passenger compartment. Adjustment can be carried out either manually by a mechanical drive or...

Adjusting the position of mirrors with electromechanical drive
The position of each mirror is adjusted both horizontally and vertically using a switch (like a joystick). In addition, there is a switch for selecting the adjustable...

Exterior rear view mirror heaters
The heated exterior mirrors are switched on simultaneously with the heated rear window. To switch on the heated rear window, press the heated rear window switch. To turn...

Folding the outside rearview mirrors
The mirror can be folded to protect it from damage when parking in a confined space.

Interior rear view mirror
The interior rearview mirror has a mechanism that changes its position to prevent the driver from being blinded by the headlights of cars driving behind. This position...

Opening the hood
1. To open the hood, pull the hood lock handle located to the left of the steering column 2. The safety lever is located to the left of the hood lock (if you are...

Remote opening of the fuel filler flap
The remote hatch release lever is located on the floor in the front left part of the passenger compartment. The lever is marked with a pictogram in the form of a fuel...

Trunk lid and rear doors
To open the trunk lid of the 4-door model, turn the key clockwise and open the lid manually. To open the rear door of the 3-door model, use the key to unlock the lock...

Remote trunk lid opening
The remote boot lid release lever is located next to the fuel filler flap release lever and is marked with a pictogram of a car with an OPEN boot.

Adjusting the height and tilt of the steering wheel
The steering wheel position can be adjusted after releasing the lock. To release the lock, move the lever down. To lock, lift the lever.

Sound signal
The horn activation key is the central element of the steering wheel.

Security systems
3-point seat belts with locking tensioner 2-point seat belts for the middle rear seat (optional) 3-point seat belts with locking tensioner for the middle rear seat...

Headlight adjustment
Before you begin adjusting your headlights, you must do the following:. 1. Adjust the pressure in all tires. 2. Place the car on a level surface at a distance of 3...

Replacing bulbs. Front interior light
1. Using a flat-head screwdriver, remove the lamp cover. 2. Replace the lamp.

Bulb replacement. Headlights, front turn signals and fog lights
Before replacing the lamp, turn off the power to the lighting fixture. Headlights 1. Wait until the lamp cools down. Put on protective glasses. 2. Disconnect the...

Replacing the bulbs. Rear combination lights
1. Open the trunk lid. 2. Remove the rear light service hatch cover. 3. Unscrew the nuts. 4. Remove the rear light. 5. Turn the desired bulb counterclockwise and remove...

Replacement of lamps. Lighting of luggage compartment
1. Open the trunk lid/tailgate. 2. Press the button and remove the cover. 3. Install the new lamp.

Replacement of lamps. Side direction indicators
1 Press the flashlight body as shown in the figure and remove it. 2 Install a new lamp to replace the faulty one.

Replacement of lamps. Glove compartment lighting
1. Open the glove compartment. 2. Using a screwdriver, remove the lamp cover. 3. Replace the lamp.

Types and power of lamps
Application Lamp type Power, W Lamp type according to IEC Image 1. High - low beam headlights H4 60/55 P43t-38 2. Front direction indicators R21W 21 BAU15S Front side...

Engine compartment fuse box
The fuse descriptions in this manual may not match your vehicle's fuse panel. All information provided is accurate at the time of publication. When inspecting the fuse...

Fuse box in the passenger compartment
Fuse Denomination Protected component of electrical equipment 1 RR WIPER 15A Headlamp combination switch, rear wiper drive 2 H/LP(LH) 10A Left headlight 3 FR WIPER 25A...

Technical specifications
Overall dimensions, mm Four-door Three-door Length 4280 mm 4045 mm Width 1695 mm 1695 mm Height 1470 mm 1470 mm Base 2500 mm 2500 mm Front track 1470 mm 1470 mm Rear...

Technical specifications. Engines
Petrol engines Diesel engine 1,4L 1,6L 1,5L Engine type 4-cylinder, in-line, DOHC Piston diameter and stroke 75.5x78.1mm 76.5x87 mm 75x84.5 mm Working volume 1,399 l...

Lubricants, operating fluids, filling tanks
Complex of service properties of motor oil for gasoline engine according to API standard SJ, SL or higher Complex of service properties of motor oil for gasoline engine...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

We recommend other sections on the topic of Hyundai manuals:

General information: User manual Hyundai Sonata 4 (2001-2012, petrol)
General information: User manual Hyundai Tucson 2 (2009-2015)

Add to social network:

Link in different formats to this section

TextHTMLBB Code