2. Connect the tip of the high voltage wire to the spark plug (engine 1.4 l) or insert a spark plug into the ignition coil (engine 1.6 l).
3. Ground the spark plug to the cylinder block.
4. To prevent the injectors from firing, remove the fuel pump relay (4) from the fuse box in the engine compartment.
5. Scrolling a cranked shaft a starter within 5-10 seconds, check up presence of a spark.
Only for 1.4L engines
6. Measure the resistance of the primary winding of the ignition coil between the terminals of the connector. Rated value: 0.87 ohm±10%.
7. Measure the resistance of the secondary winding between the high voltage coil leads. Rated value: 13.0 kΩ±15%
Only for 1.6L engines
8. Using an ohmmeter, measure the resistance of the primary winding of the ignition coil. Rated value: 0.7 ohm±15%.