Withdrawal
1. Release the power window handle bracket and remove the handle. The bracket is released by inserting a clean cloth between the handle and the door upholstery and, pulling the cloth against the ends of the bracket, hook the bracket and release it. In this case, it is necessary to pull the handle towards you so that after releasing the bracket it is removed from the splines of the power window shaft.
2. Remove the inner handle fixing screw, then push the handle towards the door hinges and remove it from the door upholstery.
3. Turn out screws of fastening of an upholstery of a door.
4. Insert the door upholstery remover between the door upholstery and the door and release the clips.
5. Remove the door trim and lower the glass.
6. Remove the screws securing the glass to the power window plate.
7. Turn out screws and a bolt of fastening of a back guide of glass.
8. Remove the fixed glass from the rear door.
9. Remove the sliding glass from the rear door.
10. Remove the outer moisture barrier from the tailgate.
11. Turn out screws and remove window regulator. Disconnect the link from the inside door handle.
12. Remove the door latch and door lock modulator.
13. Remove the outer handle.
Installation
14. Installation is carried out in the reverse order of removal.