General information about the brake system Brake system Auxiliary brake systems (ABS) Auxiliary brake system (ESP) Note: Abbreviations used in this chapter: LRK: left-hand steering column. RHD: right-hand...
Brake system maintenance Checking the vacuum brake booster For a simple test of the operation of the vacuum booster, do the following. 1. Start the engine, let it run for 1-2 minutes and stop....
Vacuum booster 1. Brake booster 2. Master cylinder 3. O-ring Withdrawal 1. Turn the ignition key to the OFF position and disconnect the negative cable from the battery. 2. Disconnect...
Master brake cylinder 1. Lid tank 2. Tank 3. Rubber seal 4. Master cylinder Withdrawal 1. Turn the ignition key to the OFF position and disconnect the negative cable from the battery. 2....
Brake lines Withdrawal 1. Disconnect the brake fluid level sensor connector from the reservoir and remove the reservoir cap. 2. Pump out a brake liquid from a tank of the main...
Brake pedal 1. Bracket 2. Pedal support 3. Stoplight switch 4. Return spring 5. Limiter 6. Finger 7. Cotter pin 8. Brake pedal Withdrawal 1. Remove the lower part of the dashboard....
Front brakes 1. Guide rod bolt 2. Bleeding port 3. Caliper bracket 4. Caliper 5. Laying of an internal block 6. Brake shoe 7. Holder Withdrawal 1. Remove the front wheel. Note:...
Rear brake mechanisms 1. Guide rod bolt 2. Bleeding port 3. Caliper bracket 4. Caliper 5. Laying of an internal block 6. Brake shoe 7. Holder Withdrawal 1. Remove the rear wheel. Note:...
Parking brake system — device 1. Parking brake pedal 2. Front parking brake cable (foot type only) 3. Equalizer assembly 4. Rear parking brake cable 5. Parking brake lever assembly 1. Back plate 2....
Parking brake system — removal Parking brake pedal (foot type) 1. Remove the lower part of the dashboard. 2. Remove the distribution block. 3. Disconnect the connector (A) parking brake switch. 4....
Parking brake system — installation Parking brake shoe (2WD) 1. Install the drive arm (E) assembled. 2. Install the top return spring (WITH) and brake pads (D). 3. Install the regulator (IN) assembly and...
Parking brake system — adjustment Parking brake shoe clearance adjustment 1. Raise the vehicle and check that the supports are secure. 2. Remove the rear wheel. 3. Remove the drive blank. 4. Rotate the...
Anti-lock braking system — device 1. Hydroelectronic control unit for anti-lock braking system 2. Front wheel speed sensor 3. Rear wheel speed sensor 4. Longitudinal acceleration sensor (only 4WD) 5....
Hydroelectronic control unit (GEBU) Left steering column 1. Piping to front left wheel 2. Piping to rear right wheel 3. Piping to rear left wheel 4. Piping to the front right wheel 5. MS2 (master brake...
Front wheel speed sensors 1. Sensor connector 2. Front wheel speed sensor Removal and installation 1. Remove the bolt (A) fastening of the sensor of frequency of rotation of a forward wheel....
Longitudinal acceleration sensor Removal and installation 1. Turn the ignition key to the OFF position and disconnect the negative cable from the battery. 2. Remove the console side cover. 3. Disconnect...
Electronic stabilization system 1. Control box (GEBU) 2. Yaw and lateral acceleration sensor (2WD); Yaw, lateral and longitudinal acceleration sensor (4WD) 3. Steering angle sensor 4. Front wheel speed...