Removal and installation
1. Turn the ignition key to the OFF position and disconnect the negative cable from the battery.
2. Remove the console side cover.
3. Disconnect the longitudinal acceleration sensor connector.
4. Turn away bolts of fastening (A).
Note: Tightening torque: 4.9 - 6.8 Nm.
5. Installation is carried out in the reverse order.
Note:
Deviation from the reference axis perpendicular to the direction of motion,±2°
Zero position initialization is necessary in the following cases:
- Replacing the longitudinal acceleration sensor.
- Replacing the control unit (GEBU).
- Occurrence of fault code C1285 (longitudinal acceleration sensor not calibrated).