Gasoline engine G4GC car Hyundai Tucson 1

Timing drive mechanism — removal
Note: This operation does not require removing the engine from the vehicle. 1. Remove the engine cover. 2. Remove the front right wheel. 3. Loosen the two mounting bolts...

Checking the technical condition of gears, tensioners, pulleys and drive belts
See similar section for G6BA engine .

Cylinder head — device

Timing drive mechanism — installation
1. Install the camshaft drive gear and tighten the mounting bolt. Holding the camshaft hexagon with an adjustable wrench (A), tighten the bolt with a spanner (B) to a...

Cylinder head — removal
Note: This operation does not require removing the engine from the vehicle. Note: 1. To avoid incorrect connections during installation, mark all connectors and hoses...

Disassembly, inspection of technical condition of parts and assembly of cylinder head
See similar section for G6BA engine .

Checking the technical condition of the cylinder head phase shifter
1. Install the gasket (A) on the block. 1. Make sure that the phase shifter assembly does not rotate. 2. Wrap vinyl film on the surfaces except those shown by the arrow...

Cylinder head — installation
Note. 1. Clean all surfaces thoroughly before installation. 2. Always use new gaskets. 3. The cylinder head gasket is metal. Be careful not to bend it. 4. Turn the...

Removal and installation the engine with gearbox assembly
Note: 1. To avoid incorrect connections during installation, mark all connectors and hoses when disconnecting them. 2. Check drive belts before removing the cylinder...

Cylinder block — device

Cylinder Block — Disassembly
1. Manual transmission - remove the flywheel. 2. Automatic transmission - remove flange. 3. Install the engine on a special stand for disassembly. 4. Remove the drive...

Cylinder block — checking technical condition
See similar section for G6BA engine. Position and meaning of part marks: 1. Position of the connecting rod mark. 2. Position of the crankshaft journal size group mark....

Cylinder Block — Assembly
Note: 1. Clean all parts thoroughly before assembly. 2. Immediately before assembly, apply a thin layer of fresh engine oil to all friction surfaces. 3. When assembling,...

Intake and exhaust systems — device

Removal and installation the intake system
1. Remove the engine cover. 2. Disconnect the connectors of the Throttle Position Sensor (A) and Idle Air Control Valve (B). 3. Disconnect the crankcase ventilation...

Removal and installation of the exhaust system
1. Remove the engine cover. 2. Disconnect the oxygen sensor (lambda probe) connector. 3. Remove the front muffler (A). 4. Remove the thermal insulation. 5. Remove the...

Tightening torques

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Add to social network:

Link in different formats to this section

TextHTMLBB Code