Diesel car engine Hyundai Tucson 2

General information about diesel engines

On-car service
Compression check Note: If there is a loss of power, increased fuel consumption or increased oil consumption, it is necessary to check the compression in the engine...

Powertrain assembly — removal
Attention. To avoid damage to painted surfaces, use protective coatings. To avoid damage, disconnect the connectors carefully, holding the connector with your hand....

Powertrain assembly — installation
1. Installation is carried out in reverse order. 2. Adjust the gear shift cable. 3. Fill with engine oil. 4. Fill the gearbox with fluid. 5. Clean the battery terminals...

Gas distribution mechanism drive-device
1. Auxiliary equipment drive belt 2. Engine support bracket 3. Intermediate roller No.1 4. Fuel injection pump drive chain sprocket service hole plug 5. Crankshaft...

Gas distribution mechanism drive-removal
Note: This procedure does not require engine removal. Attention. To avoid damage to painted surfaces, use protective coatings. To avoid damage, disconnect the connectors...

Timing drive — installation
1. After installing the timing chain (A) "A" and aligning the timing marks (D) of the high-pressure pump sprocket (B) and the crankshaft sprocket (C), install the...

Cylinder head assembly — device
1. Cylinder head cover 2. Additional cylinder head gasket 3. Main cylinder head gasket 1. Front camshaft bearing cap 2. Exhaust camshaft bearing cap 3. Intake camshaft...

Cylinder head assembly — removal
Attention. To avoid damage to painted surfaces, use protective coatings. To avoid damaging the cylinder head, wait until the coolant temperature drops to room...

Cylinder head assembly — disassembly
1. Remove the valves: Using special tools (09222-ЗКООО, 09222-2А100) (A), compress the valve spring and remove the crackers (B). Remove the spring plate (C). Remove the...

Checking the technical condition of the cylinder head assembly
Cylinder head 1. Check the non-flatness of the surface of the joint between the cylinder head and the cylinder block and manifolds. To do this, use a special ruler and a...

Cylinder head assembly — assembly
Note: Wash all parts before assembly. Before installation, apply a thin layer of motor oil to all rubbing surfaces. Replace all sealing cuffs with new ones. 1. Install...

Cylinder head assembly — installation
Note: Wash all parts before installation. Always use new cylinder head gaskets and exhaust and intake manifold gaskets. Always use new cylinder head bolts. Turn the...

Cylinder block — device
1. Piston rings 2. Piston 3. Connecting rod 4. Piston pin 5. Retaining ring 6. Connecting rod bearing shells 7. Cylinder block 8. Oil nozzle 9. Crankshaft position...

Cylinder Block — Disassembly
Attention. To avoid damage to painted surfaces, use protective coatings. To avoid damaging the cylinder head, wait until the coolant temperature drops to room...

Checking the technical condition of the cylinder block
Connecting rods 1. Check the end clearance between the piston and connecting rod. Using a set of feeler gauges, measure the end clearance by moving the connecting rod...

Cylinder Block — Assembly
Note: Wash all parts before assembly. Before installing parts, apply a thin layer of motor oil to all rubbing surfaces. Replace all gaskets, O-rings and seals. 1....

Tightening torques for threaded connections

Special tools and devices

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

We recommend other sections on the topic of Hyundai manuals:

Power unit: Diesel engines Hyundai Elantra 3 (2000-2006)

Add to social network:

Link in different formats to this section

TextHTMLBB Code