Car automatic transmission Hyundai Tucson 2

General information about automatic transmission

On-car service
Checking the transmission oil level in the gearbox Note: Checking the transmission oil level is not usually required during routine maintenance. Check the oil level if a...

Automatic transmission assembly — device
1. Gearbox housing 2. Downshift and reverse gear brake disc 3. Reverse gear reduction return plate 4. Retaining ring 5. Front pinion with internal engagement 6. Front...

Automatic transmission assembly — removal and installation
Removal 1. Remove the following parts: Engine cover (B) and air duct (A). Air filter assembly (C). Battery and shelf (D). A6MF1 A6LF2 2. Remove the ground wire by...

Valve body
1. Breather hose 2. Oil level check plug 3. Valve body 4. Oil temperature sensor 5. Solenoid valve 6. Valve body cover 7. Lock switch 8. T/Con (VFS N/L) 9. 35R (VFS.N/H)...

Removal and installation the electromagnetic valve
1. Remove the battery and battery tray. 2. Remove the engine protection (A). 3. Unscrew the drain plug and drain the automatic transmission oil. 4. Loosen the eye bolt...

Removal and installation the gearbox control unit
Note: If the vehicle is equipped with an immobilizer or push-button start system, perform the "Key Learning" procedure at the same time ("Key Teaching"). 1. Turn the...

Removal and installation the primary and secondary shaft speed sensors
1. Remove the battery and battery tray. 2. Remove the engine protection (A). 3. Unscrew the drain plug and drain the automatic transmission oil. 4. Loosen the eye bolt...

Removal and installation the automatic transmission oil temperature sensor
1. Remove the battery and battery tray. 2. Remove the engine protection (A). 3. Unscrew the drain plug and drain the automatic transmission oil. 4. Loosen the eye bolt...

Removal and installation the retarder switch
1. Move the interior lever and the manual control lever to the "N" position. 2. Remove the battery and battery tray. 3. Remove the air filter assembly. 4. Unscrew the...

Gear selector
1. Selector handle 2. Gearbox selector assembly 3. Gearbox operating mode selection cable 4. Manual control lever Removal and installation 1. Remove the shift lever...

Transfer case
The operations are similar to those carried out for manual transmission .

Intelligent Torque Control (ITCC)
The operations are similar to those carried out for manual transmission .

Tightening torques
Caution: Always adhere to the specified tightening torques. A6MF1 A6LF2

Lubricants and sealants

Special tools and devices

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

We recommend other sections on the topic of Hyundai manuals:

Transmission: Automatic gearbox Hyundai Accent 3 (2005-2010)
Transmission: Automatic gearbox Hyundai Elantra 3 (2000-2006)
Transmission: Automatic gearbox Hyundai Getz (2002-2011)
Transmission: Automatic gearbox Hyundai Sonata 4 (2001-2012, petrol)
Transmission: Automatic gearbox Hyundai Santa Fe 2 (2007-2012, petrol)
Transmission: Automatic gearbox Hyundai Matrix (2001-2010, petrol)

Add to social network:

Link in different formats to this section

TextHTMLBB Code