Car automatic transmission Hyundai Getz

Automatic transmission specifications
Technical specifications Model - A4AF3 Type - four-speed, with one reverse gear Hydrotransformer type - with three-wheel guide apparatus, single-stage with two reaction...

Malfunction Indicator Lamp (MIL)
The Hyundai Getz MIL warning light comes on when there are faults in the engine and automatic transmission control systems. However, the MIL will not come on after three...

Reading diagnostic trouble codes
Using the HI-SCAN PRO scanner 1. Turn off the ignition. 2. Connect the Hi-Scan Pro scanner to the diagnostic connector. 3. Turn on the ignition. 4. Read the fault codes...

Checking Transmission Fluid Pressure
1. Start the engine until the gearbox warms up. 2. Raise the front of the vehicle so that the drive wheels can turn freely. 3. Connect the tachometer and position it so...

Testing the joint operation of an automatic transmission and engine on a stationary vehicle
The test is performed to determine the maximum engine speed when the selector lever is in the "D" or "R" positions, and to check the operation of the torque converter...

Checking the fluid level in an automatic transmission
Warning! The vehicle must be parked on a level, horizontal surface. 1. Drive until the gearbox warms up to a temperature of 80–90°C. 2. Park the car on a level...

Selector lever — adjustment
1. Move the selector lever to all positions. Check that the selector lever position matches the selector lever indication. 2. Make sure that the selector lever is set to...

Adjusting the pressure in the main line
7. Turn the adjusting screw of the distributor so that the pressure in the line reaches the required value. Turning the screw clockwise leads to a decrease in pressure...

Adjusting the pressure drop
Without diagnostic tool "Scan" 1. Remove the parts up to the oil filter, as when adjusting the pressure in the line, but it is not necessary to remove the valve block....

Replacing the drive shaft oil seal ring
1. Disconnect the drive shaft from the gearbox. 2. Using a flat-head screwdriver, remove the sealing ring from the gearbox socket. 3. Using drift 09431–21200, install a...

Replacement of the electronic control unit of the engine and gearbox
The electronic control unit for the engine and gearbox of the car is located under the instrument panel on the driver's side above the brake pedal.

Removal and installation of automatic transmission
Removal 1. First disconnect the wire from the negative terminal of the battery, then from the positive terminal and remove the battery. 2. Remove the five bolts and...

Automatic transmission selector lever — removal
10. Remove the screws, press the button up, then press it down and remove the selector lever handle button. Examination Check the operation of the transmission control...

Installing the selector lever lock mechanism
Note: To ensure normal operation of the Hyundai Getz selector lever lock mechanism, install in the following sequence. Installing the locking cam 1. Move the locking cam...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

We recommend other sections on the topic of Hyundai manuals:

Transmission: Automatic gearbox Hyundai Accent 3 (2005-2010)
Transmission: Automatic gearbox Hyundai Elantra 3 (2000-2006)
Transmission: Automatic gearbox Hyundai Sonata 4 (2001-2012, petrol)
Transmission: Automatic gearbox Hyundai Santa Fe 2 (2007-2012, petrol)
Transmission: Automatic gearbox Hyundai Tucson 2 (2009-2015)
Transmission: Automatic gearbox Hyundai Matrix (2001-2010, petrol)

Add to social network:

Link in different formats to this section

TextHTMLBB Code