7. Turn the adjusting screw of the distributor so that the pressure in the line reaches the required value. Turning the screw clockwise leads to a decrease in pressure and, conversely, counterclockwise - to an increase.
- Nominal pressure: 860-900 kPa
- Pressure change when turning the screw by 1 revolution: 38 kPa
8. Check that the sealing ring is installed on the top of the valve body.
9. Replace the solenoid valve wire connector sealing ring.
10. Install the valve body to the crankcase and insert the solenoid valve connector into the crankcase. Make sure the toothed part of the connector is installed as shown in the figure.
13. Install the new oil pan gasket and oil pan.
14. Fill the automatic transmission with the required amount of transmission fluid.
15. Check the pressure in the line.
The publication is borrowed from the website: hyundaibook