Removal and installation the electromagnetic valve (Hyundai Tucson LM)

1. Remove the battery and battery tray.

2. Remove the engine protection (A).



3. Unscrew the drain plug and drain the automatic transmission oil.

4. Loosen the eye bolt (B) and remove the valve body cover (A).

Note:

1. Tightening torque:

• Valve body cover bolts (A): 9.8-11.8 Nm.
• Eye bolt (B): 39.2 - 44.1 Nm.

2. First, unscrew the bolts located in the engine compartment.

3. Replace the eye bolt gasket with a new one.

5. Disconnect the solenoid valve (B), the oil temperature sensor connector (A), and then remove the three mounting bolts.

(This publication is based on information from the portal: «HyundaiBook.ru»)

Note: Tightening torque: 9.8-11.8 Nm.

6. Remove the bracket and remove the solenoid valve (A).





7. Installation is carried out in the reverse order of removal.

Note:

• Apply automatic transmission fluid or petroleum jelly to the O-rings to prevent damage.
• Apply a 2.5 mm bead of Threebond 1281B or LOCTITE FMD-546 sealant to the valve body cover mating surfaces.
• Add oil to the gearbox.