Car clutch repair Hyundai Tucson 1

Clutch specifications
Clutch with hydraulic drive, single-disk with central pressure spring. Clutch casing is attached to flywheel with bolts, and is connected to pressure plate with elastic...

Clutch housing and driven disc — device

Checking the technical condition of the clutch
Clutch housing 1. Clean the clutch housing from dust with a vacuum cleaner or cloth, do not use compressed air. Check the seals for oil leaks. If any are found, replace...

Disassembling the clutch
1. Remove the gearbox (see chapter " Transmission "). 2. If the clutch housing is secured to the flywheel, the release bearing can be removed using special pliers. 1)...

Clutch assembly
1. Apply CASMOLY L 9508 universal grease to the clutch disc splines. 2. Using the 09411-11000 tool, install the driven disk onto the flywheel. 3. Install the clutch...

Clutch master cylinder — device

Clutch Master Cylinder — Removal
1. Drain the brake fluid from the system through the air bleed nipple (A). 2. Remove the pusher (A) by removing the cotter pin (C) and washer. 3. Disconnect the supply...

Clutch Master Cylinder — Installation
1. Connect the tube (A) to the master cylinder. 2. Connect the tube to the hose manually and then tighten to the required force. 3. Install the tube into the bracket and...

Clutch pedal — device

Checking the technical condition of the clutch pedal parts
1. Check the pedal axle and bushing for wear. 2. Check the clutch pedal for bending or tilting. 3. Check the return spring for damage or weakening. 4. Check the pedal...

Checking the ignition interlock switch
Remove the ignition interlock switch and check the integrity of the circuit between the switch terminals. Replacing the clutch pedal 1. Remove the pusher (A) by removing...

Clutch slave cylinder — device

Clutch slave cylinder — disassembly
1. Disconnect the connecting hose, spring, pusher and boot from the cylinder. 2. Carefully remove dirt around the bore of the working cylinder under the piston. 3....

Clutch slave cylinder — checking technical condition
1. Check the working cylinder mirror for corrosion or damage. 2. Using a bore gauge, check the inner diameter of the cylinder in three places (lower, middle and upper...