Gasoline car engine Hyundai Tucson 2

General information about gasoline engines

On-car service
Compression check Note: If there is a loss of power, increased fuel consumption or increased oil consumption, it is necessary to check the compression in the engine...

Powertrain assembly
Removal Attention. To avoid damage to painted surfaces, use protective coatings. To avoid damage, disconnect the connectors carefully, holding the connector with your...

Gas distribution mechanism drive-device
2.0L engines (with oil pump) 1. Intake camshaft 2. Phase shifter 3. Exhaust camshaft 4. Phase shifter 5. Gas distribution mechanism drive chain 6. Chain guide 7. Chain...

Gas distribution mechanism drive-removal
1. Disconnect the negative cable from the battery. 2. Remove the engine cover (A). 3. Remove the front right wheel. 4. Remove the side cover. 5. Set the piston of...

Timing drive — installation
1. Install the balance shaft (oil pump) drive chain. 2. Install the crankshaft timing chain sprocket (B). 3. Install the chain oil nozzle (A). Note: Tightening torque:...

Checking the technical condition of the timing drive
Sprockets, hydraulic tensioner, chain guide and tensioner lever 1. Check the teeth of the camshaft and crankshaft drive sprockets for excessive wear, chips, and damage....

Cylinder head — device
1. Camshaft bearing cap 2. Front camshaft bearing cap 3. Exhaust camshaft 4. Intake camshaft 5. Exhaust camshaft phase shifter assembly 6. Intake camshaft phase shifter...

Cylinder head — removal
Note: It is not necessary to remove the engine to remove the cylinder head. Attention. To prevent damage to the paintwork of the body wings, it is necessary to use a...

Cylinder head — installation
Note: Wash all parts before installation. Always use new cylinder head gaskets and exhaust and intake manifold gaskets. Always use new cylinder head bolts. The cylinder...

Cylinder head — disassembly
Note: Mark all lifters, valves and springs to match their location in the cylinder head to ensure that their original locations are not changed during assembly. 1....

Cylinder head — technical condition check
Cylinder head 1. Check the non-flatness of the surface of the cylinder head-to-block joint. To do this, use a special ruler and a set of feeler gauges. Placing the ruler...

Cylinder head — assembly
Note: Wash all parts before assembly. Before installation, apply a thin layer of motor oil to all rubbing surfaces. Replace all sealing cuffs with new ones. 1. Install...

Cylinder block — device
1. Piston rings 2. Piston 3. Connecting rod 4. Upper connecting rod bearing shell 5. Piston pin 6. Lower connecting rod bearing shell 7. Connecting rod bearing cap 8....

Cylinder Block — Disassembly
1. Manual transmission: remove the flywheel. 2. Automatic transmission: remove the drive disc. 3. To disassemble the engine, install it on the stand. 4. Remove the...

Cylinder block — checking technical condition
Connecting rods and crankshaft 1. Check the connecting rod end clearance. Using a set of feeler gauges, measure the end clearance by moving the connecting rod...

Cylinder Block — Assembly
Note: Wash all parts before assembly. Before installing parts, apply a thin layer of motor oil to all rubbing surfaces. Replace all gaskets, O-rings and seals. 1....

Tightening torques for threaded connections
Note: GRM - gas distribution mechanism.

Special devices and tools

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

We recommend other sections on the topic of Hyundai manuals:

Power unit: Gasoline engines Hyundai Elantra 3 (2000-2006)

Add to social network:

Link in different formats to this section

TextHTMLBB Code