Car engine cooling system Hyundai Tucson 1

Technical characteristics of the cooling system

Replacing the coolant
1. Set the heater temperature control lever to the highest temperature. Touch it to make sure the engine and radiator are cool. 2. Remove the radiator cap. 3. Unscrew...

Checking the radiator cap
1. Remove the radiator cap, wet the cap gasket with coolant and install the cap on the testing device. 2. Create pressure with the device until the pressure gauge needle...

Checking the tightness of the cooling system
1. Wait until the engine cools down, then carefully remove the radiator cap. 2. Check the coolant level, which should be at the lower edge of the radiator filler neck....

Checking the technical condition
Water pump 1. Check the water pump body for cracks, damage, chips. If necessary, replace the water pump assembly. 2. Check the pump bearing for noise and increased...

Engine cooling system G5BA — device

G5BA Engine Cooling System — Removal
Water pump 1. Drain the coolant from the system. 2. Remove the accessory drive belt. 3. Remove the camshaft drive belt. 4. Remove the intermediate pulley of the drive...

G5BA Engine Cooling System — Installation
Water pump 1. Install the water pump (A) and new gasket (B). 2. Tighten the eight bolts to a torque of 15-22 Nm. 3. Install the drive belt intermediate pulley. 4....

Engine cooling system G4GC — device

G4GC Engine Cooling System — Removal
Water pump 1. Drain the coolant from the system. 2. Remove the accessory drive belt. 3. Remove the camshaft drive belt. 4. Remove the intermediate pulley of the drive...

G4GC Engine Cooling System — Installation
Water pump 1. Install the water pump (B) and a new gasket. Tighten the 3 bolts to 20-27 Nm. 2. Install the generator bracket (A) and secure it with two bolts (C). 3....

Engine cooling system D4EA — device

D4EA Engine Cooling System — Removal and Installation
Water pump 1. Drain the coolant from the system. 2. Remove the drive belt. 3. Remove the rear drive belt cover (A). 4. Loosen four bolts (one bolt A and three bolts B)....

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

We recommend other sections on the topic of Hyundai manuals:

Power unit: Cooling system Hyundai Accent 2 (1999-2005)
Power unit: Cooling system Hyundai Elantra 3 (2000-2006)
Power unit: Cooling system Hyundai Getz (2002-2011)
Power unit: Cooling system Hyundai Sonata 3 (1993-1998)
Engine 2.7 liter: Cooling system Hyundai Santa Fe 2 (2007-2012, petrol)
Power unit: Cooling and lubrication system Hyundai Matrix (2001-2010, petrol)

Add to social network:

Link in different formats to this section

TextHTMLBB Code