Checking spark plugs and high voltage wires 2.0L petrol engine 1. Disconnect the high voltage wires shown in the figure. Note. Disconnect the high voltage wires from the spark plugs by the lug. 2. Using a spark...
Ignition coil 1. Measure the resistance of the primary line of the ignition coil. The measurement is made between the coil terminals: 1 and 2, 1 and 3 (engine 2.0 l), 1 and 4, 2 and...
Battery charging system — general information The battery charging system includes a battery, a generator with a built-in voltage regulator and a test lamp with wiring. The generator has six built-in diodes (three...
Generator — check The check of the generator output current is carried out in order to determine whether the generator output current corresponds to the nominal value. Preparation for...
Removing the generator Gasoline engine volume 2.0 l 1. Disconnect the negative terminal of the battery. 2. Disconnect connectors A and B from generator C. Unscrew bolts A, B, C and remove the...
Generator elements 2.0 liter petrol engine 2.7 liter petrol engine 2.0 liter diesel engine
Checking the technical condition of the battery 1. Make sure the ignition is off. 2. Disconnect the terminals from the battery (primarily negative «-»). 3. Remove the battery from the vehicle. 4. Inspect the battery...
Engine start system — removal 1. Disconnect ground (negative wire «-») from the battery. 2. Disconnect wiring A, B, E, D from the traction relay. Gas engine diesel engine 3. Remove the starter...
Starter device Starter for 2.0 and 2.7 liter petrol engines 2.0 liter diesel engine starter
Checking the technical condition of the starter Adjusting the gap between the end face of the drive gear and the stop 1. Disconnect the field winding wire from the output «M» traction relay. 2. Connect a 12-volt...
Cruise control — removal and installation 1. Loosen lock nut A, disconnect cruise control cable B by pulling it out of groove C. 2. Remove cover A, disconnect cable B from cruise control drive C. 3. Unscrew the...