Car airbags Hyundai Tucson 1

Airbag — General Information
The airbag system provides driver and passenger protection in addition to the safety belts to reduce the risk and severity of injury by deploying and inflating the...

Airbag — device

Precautionary measures
Failure to maintain the airbag at the required intervals may result in the airbag accidentally deploying during work, which may cause serious injury. On the other hand,...

Warning labels
Warning signs relating to the airbag system are located on the vehicle in the places shown in the figure. When working on the system, follow the instructions on these...

Electronic airbag control unit (EACU)
The SRS airbag system includes complex electrical and electronic devices. For this reason, special care is required when handling system components. The location of the...

Autonomous operation of the airbag malfunction indicator lamp
The SRS airbag system malfunction indicator lamp, located in the instrument cluster, provides information on the system status based on a test signal from the ECU. In...

Driver Airbag Module — Device

Removal and installation of the PBB module
1. Disconnect the wire from the negative terminal of the battery. 2. Using a hex key, loosen the bolts securing the steering wheel side protective cover and the airbag...

Checking the technical condition of the PBB module
If any of the parts are found to be faulty during the technical inspection, replace the airbag module with a new one. Dispose of the old module in accordance with the...

Passenger Airbag Module — Removal and Installation
1. Disconnect the wire from the negative terminal ("-") of the battery. 2. Remove the glove box. 3. Disconnect the PBP module connector. 4. Remove the instrument panel...

Elements of the airbag system — device

Contact disc of the airbag system
The contact disk, installed between the steering column and the steering wheel, consists of two conductive spiral springs. It ensures the rotation of the steering wheel...

Removal the contact disk
1. Disconnect the wire from the negative terminal ("-") of the battery. 2. Remove the airbag module. 3. Remove the steering wheel. 4. Press the lock and disconnect the...

Checking the technical condition of the contact disk
1. Check the connector and protective tube for damage and deformation of the terminals. 2. If at least one of the following faults is detected, replace the contact disk...

Seat Belt Pretensioner (SBP)
When a frontal impact of a certain force occurs, the airbag control unit issues a command to the seat belt pretensioner gas generator igniter. Under the action of the...

Seat Belt Force Limiter (SBFL)
The force limiter serves to reduce the pressure of the seat belt on the chest during a collision. When a certain value of belt pressure is reached, the limiter torsion...

Removal the seat belt pretensioner
1. Disconnect the wire from the negative terminal ("-") of the battery. 2. Remove the door sill trim. 3. Loosen the lower anchor bolt and remove the lower trim of the...

Side airbag sensor
1. Disconnect the wire from the negative terminal ("-") of the battery. 2. Remove the door sill trim. 3. Loosen the lower anchor bolt and remove the lower trim of the...

Front airbag sensor
1. Disconnect the wire from the negative terminal ("-") of the battery. 2. Remove the radiator guard. 3. Unscrew the two mounting bolts and remove the sensors,...

Airbag disposal plan

Diagnostics of the airbag system
1. Connect the Hi-Scan Pro device connector to the data transmission line connector located under the dashboard. 2. Set the ignition key to the "ON" position, turn on...

Disposal of airbag modules
Before disposing of a vehicle equipped with air bags and disposing of air bag modules, perform the following air bag deployment procedures. Triggered inside the vehicle...

Special tools and accessories

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Add to social network:

Link in different formats to this section

TextHTMLBB Code