Passenger Airbag Module — Removal and Installation (Hyundai Tucson JM)

1. Disconnect the wire from the negative terminal ("-") of the battery.

2. Remove the glove box.

3. Disconnect the PBP module connector.

4. Remove the instrument panel trim, remove the passenger airbag module.

[The original article is posted on the portal: HYUNDAIBOOK]

5. The passenger airbag module trim is integral with the instrument panel trim, so after the airbag has deployed, the instrument panel trim must be replaced.

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This article has been reviewed by: Konstantin Smirnov

Add to social network:

Tucson 1: Airbags

Checking the technical condition of the PBB module
Removal and installation of the PBB module
Driver Airbag Module — Device
Autonomous operation of the airbag malfunction indicator lamp
Electronic airbag control unit (EACU)

Elements of the airbag system — device
Contact disc of the airbag system
Removal the contact disk
Checking the technical condition of the contact disk
Seat Belt Pretensioner (SBP)

We recommend other articles on the topic of Hyundai manuals:

Removal and installation the passenger airbag Hyundai Accent 3 (2005-2010)
Passenger presence detection system Hyundai Elantra 3 (2000-2006)
Front passenger airbag Hyundai Getz (2002-2011)
Passenger airbag module Hyundai Sonata 4 (2001-2012, petrol)
Table 1.5. Fuses of the block located in the passenger… Hyundai Santa Fe 2 (2007-2012, petrol)
Airbag module and airbag inflator (gas generator) Hyundai Matrix (2001-2010, petrol)

Link in different formats to this article

TextHTMLBB Code

Visitor comments

No comments yet