Removal
Warnings!
- 1. Do not disassemble or repair any airbag system components.
- 2. If the airbag has been dropped or exposed to water or oil, or if there are cracks, dents, or other defects in the housing or connector, replace the airbag.
- 3. The removed airbag should be stored in a clean, dry place with the front side facing up. Do not place any foreign objects on the airbag that could cause serious injury when the airbag deploys.
- 4. Do not expose the airbag to temperatures above 93°C.
- 5. An undeployed airbag must be positioned only in accordance with the prescribed procedures.
- 6. Do not attempt to measure the resistance of the airbag inflator circuit, as this may result in unauthorized deployment of the driver's airbag.
- 7. After the airbag has been deployed, it must be replaced along with the wire that was exposed to the gases of the pyrotechnic gas generator.
1. Disconnect the cable from the negative terminal of the battery.
Caution: Before servicing the airbag system, make sure that at least 30 seconds have passed after the ignition has been switched off and the negative battery cable has been disconnected.
2. Remove the glove box.
3. Disconnect the electrical connector from the airbag.
4. Remove the instrument panel and airbag.
5. The outer layer of the front passenger airbag is integrated with the instrument panel, so when the airbag deploys, the instrument panel must be replaced.
The material is republished from the web portal [hyundaibook.ru]