Contents: Removal ⇓ Checking the airbag ⇓
Removal
1. Disconnect the cable from the negative terminal of the battery.
Warning: Before servicing the airbag system, make sure that at least 30 seconds have passed after the ignition has been turned off and the negative battery cable has been disconnected.
2. Remove the three driver's airbag mounting bolts.
Warnings: The removed airbag must be stored in a clean, dry place, with the front side facing up.
4. Loosen the steering wheel mounting nut. Remove the steering wheel using puller 09561–11002.
Caution: Do not knock on the steering wheel, as this may damage the steering column.
6. When disconnecting the airbag coil wire electrical connector, release the lock by pulling it toward the outside of the vehicle.
Caution: Do not use excessive force when disconnecting the airbag coil wire electrical connector.
Checking the airbag
If there are any defects, the airbag must be replaced.
Warning! Do not attempt to measure the resistance of the airbag inflator circuit, as this may result in unauthorized deployment of the driver's airbag.
1. Check the airbag cover for dents, cracks or deformation.
2. Check the airbag for dents, cracks or deformation.
3. Check the condition of the hooks and connectors for damage, oxidation of the connector contacts and damage to the wiring harness.
4. Inspect the airbag inflator housing for dents, cracks or deformation.
5. Place the airbag on the steering wheel to check alignment and fit.