1. Multi-function switches; 2. Contact coil; 3. Steering wheel; 4. Driver airbag
Withdrawal
Attention: after disconnecting the battery terminal, wait at least 3 minutes.
1. Disconnect a wire from the negative plug of joint stock bank.
2. Turn off three screws of an airbag. Tightening torque: 8-11 Nm.
3. Disconnect the horn connector (1). Unhook the latch (2) and disconnect the airbag connector (3).
4. Remove a steering wheel and casings of a steering column.
5. Disconnect the rotating contact and horn connectors. Remove the rotating contact joint.
Installation
Note: When installing the rotating contact joint, make sure it is in the neutral position. In this case, the front wheels must be installed strictly straight.
6. Installation is carried out in the reverse order of removal.