Withdrawal
Attention: after disconnecting the battery terminal, wait at least 3 minutes.
1. Disconnect a wire from the negative plug of joint stock bank.
2. Disconnect the front airbag connectors.
3. Remove the screw, disconnect the connector and remove the front impact sensor on the right side. Tightening torque: 7-8 Nm.
4. Remove the front bumper.
5. Remove the screw, disconnect the connector and remove the front impact sensor on the left side. Tightening torque: 7-8 Nm.
Installation
6. Installation is carried out in the reverse order of removal.