Car engine lubrication system Hyundai Tucson 1

Characteristics of the lubrication system
Note: To ensure the best performance and engine protection under all operating conditions, use only oils that: 1. Comply with API classification standards 2. Have an SAE...

Lubrication system of the G6BA engine — device

Removal the oil pump of the G6BA engine
1. Drain the engine oil. 2. Remove the front right wheel. 3. Remove the right side cover. 4. Remove the front exhaust pipe. 5. Remove the generator. 6. Remove the drive...

Checking the technical condition of the lubrication system of the G6BA engine
1. Check the pressure reducing valve. Lubricate the plunger with engine oil and check the smoothness of its movement in the hole. If a defect is found, replace the...

Installing the oil pump of the G6BA engine
1. Install the outer and inner rotor into the oil pump housing. 2. Install the oil pump cover (A) and tighten the mounting screws (B) to a tightening torque of 8-12 Nm....

G4GC engine lubrication system — device

Removal the oil pump of the G4GC engine
1. Drain the engine oil. 2. Remove the drive belt. 3. Turn the crankshaft until the white mark on the crankshaft pulley aligns with the mark on the lower cover. 4....

Checking the technical condition of the lubrication system of the G4GC engine
Look " Technical condition check. Engine G6BA ".

Installing the oil pump of the G4GC engine
Installation is carried out in the reverse order of removal. Note: To prevent oil leaks, it is necessary to apply sealant to the holes where the oil pump housing is...

Diesel engine lubrication system (D4EA) — device

Removal the oil pump of the D4EA engine
1. Drain the engine oil. 2. Remove the drive pulley (A). 3. Remove the camshaft drive toothed belt. 4. Remove the belt tensioner. 5. Remove the back cover (A). 6....

Checking the technical condition of the D4EA engine
1. Using a feeler gauge, measure the gap between the inner (A) and outer (B) rotor. The permissible gap value is 0.120-0.200 mm. If the gap exceeds the permissible...

Installing the oil pump of the D4EA engine
1. Install the oil pump housing on the cylinder block and tighten the mounting bolts. The tightening torque of the mounting bolts is 20-27 Nm. Note: Apply Loctite 5900,...

Tightening torques

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

We recommend other sections on the topic of Hyundai manuals:

Power unit: Lubrication system Hyundai Accent 2 (1999-2005)
Power unit: Lubrication system Hyundai Elantra 1 (1990-1995, petrol)
Power unit: Lubrication system Hyundai Getz (2002-2011)
Power unit: Lubrication system Hyundai Sonata 4 (2001-2012, petrol)

Add to social network:

Link in different formats to this section

TextHTMLBB Code