Motor oils and their applications Depending on the operating conditions, different requirements are imposed on engine oils. Therefore, it is very difficult to accurately select a lubricant according to...
Engine lubrication process The engines are equipped with a pressure lubrication system. The oil is supplied by the oil pump through the oil receiver screen from the oil sump and passes under...
Oil sump — removal and installation (all engines) Withdrawal Disconnect the ground wire from the battery. Raise the car on a lift. Drain the engine oil. Remove the protective cover. Remove the oil pan mounting bolts....
Oil pressure — check. Oil pressure sensor — check Check the engine oil level, add oil to the minimum mark. Warm up the engine in motion, the oil temperature should be at least 80°C. Disconnect the wire from the oil...
Oil pump — repair Disassembly Remove the oil pump from the engine. To remove the pump, it is necessary to disconnect and remove the elements of the camshaft drive (lower part), as well as...
Pressure reducing valve — removal and installation The valve serves to maintain a constant oil pressure. It is built into the oil pump. If the oil pressure warning lamp is on or flashing, this indicates insufficient oil...
Engine oil level check/oil change The engine oil level should be checked approximately every 600 km, but at least once a week. The vehicle must be parked on a level surface and the engine must be warm....