Car front suspension repair Hyundai Elantra 1

Front suspension device
Front suspension elements (models produced before 2002) 1 - shock absorber strut; 2 - lower transverse arm; 3 - anti-roll bar; 4 - stabilizer rod. Front suspension...

General description of the front suspension
The front suspension is independent, MacPherson type, with telescopic hydraulic shock absorbers. The suspension of each wheel includes: shock absorber strut, wheel...

Checking the elements of the front suspension of the car
Checking wheel play The front wheels move on double-row ball bearings. They can withstand a mileage of more than 100 thousand km with the grease installed. However, they...

Shock absorber strut — removal and installation
Removal With the vehicle on the ground, loosen the central nut securing the wheel hub. Raise the car evenly from the front so that the stabilizer is not under tension....

Shock absorber strut — disassembly and assembly
Elements of the front suspension shock absorber strut (models produced before 2002) 1 - rack; 2 - spring; 3 - protective cover; 4 - compression stroke buffer; 5 - spring...

Lower arm — removal and installation
Lower suspension arm mounting elements (models produced before 2002) 1 - lower suspension arm; 2 - front hub; 3 - stabilizer strut; 4 - rear mounting bushing; 5 -...

Rear Lower Control Arm Bushing (Pre-2002 Models) — Replacement
Apply soapy water to the joint between the arm axle and the old bushing, then use a screwdriver to remove the old bushing. Apply soapy water to the lever axle (3) and...

Lower control arm (models from 2002) — disassembly and assembly
Disassembly Using tools or suitable pipe sections, press out the front lower arm support. Using a screwdriver, remove the boot (2) of the ball joint (1) of the lower...

Anti-roll bar — removal and installation
Removal Remove the cross beam. Loosen the bolts and disconnect the strut from the anti-roll bar. Loosen the bolt and remove the bracket (2) securing the stabilizer...

Ball joint protective cover, stabilizer struts — replacement
Remove the anti-roll bar (1). After removing the "wire", remove the protective cover. Place general purpose grease inside the protective boot (A). Wrap tape (1) around...

Front wheel hub — disassembly and assembly
Disassembly Internal elements of the steering knuckle 1 - hub; 2 - brake shield; 3 - rotary disk; 4 - bearing; 5 - retaining ring. Remove the inner seal. Using the tool,...

Front wheel hub — removal and installation
Front wheel hub (models produced before 2002) 1 - drive shaft; 2 - bearing; 3 - hub; 4 - steering knuckle. Front wheel hub (models from 2002) 1 - cotter pin; 2 - washer;...

Wheel alignment angles
Convergence Toe-in is the position of the front wheels when the distance between the side surfaces of the tires at the front is less than at the rear, while reverse...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

We recommend other sections on the topic of Hyundai manuals:

Chassis: Front suspension Hyundai Accent 3 (2005-2010)
Chassis: Front suspension Hyundai Sonata 3 (1993-1998)

Add to social network:

Link in different formats to this section

TextHTMLBB Code

Elantra 3 (2000-2006)