Car clutch repair Hyundai Elantra 1

Clutch operation
The transmission of force between the engine and the gearbox is carried out by means of a clutch, which operates using the force of friction. Two adjacent surfaces clamp...

Checking the clutch
It is impossible to detect wear on the driven disk when installed. The first indication of this is slippage (slippage) clutch. Clutch slippage is noticeable when driving...

Driving with a faulty clutch drive
Turning off the transmission Release the gas and, when driving slowly or when the vehicle is braking slightly, push the gear shift lever toward neutral. Moving off Turn...

Clutch — removal and installation
Clutch elements 1 - leading (pressure) clutch disc; 2 - driven clutch disc. Removal Remove the gearbox. Mark the position of the drive disc on the engine flywheel. By...

Checking the clutch elements
Check the clutch pressure plate for damage or warping. If damage is found, replace the pressure plate. Typical broken clutch disc springs Check the clutch disc friction...

Release bearing — removal and installation
Release bearing mounting elements (models before 2000.) 1 - gearbox housing; 2 - clutch slave cylinder; 3 - leading clutch disc; 4 - driven disk; 5 - spring; 6 - release...

Clutch pedal free play — checking and adjusting
If there are difficulties when disengaging and engaging the clutch, check the height and free travel of the clutch pedal. Measure the distance from the rubber pedal pad...

Bleeding the Clutch System
Air must be removed from the clutch system when disengaging the hydraulic drives or when removing system parts. Air is removed from the system as follows: Raise the car...

Clutch release sensor — check
Connect an ohmmeter to the clutch release sensor terminals. The clutch release sensor is in good condition if the circuit is open when the sensor rod extends less than 4...

Clutch Master Cylinder — Removal, Installation and Repair
Clutch Master Cylinder Components (models before 2000.) 1 - lid; 2 - tank; 3 - clamp; 4 - body; 5 - piston assembly; 6 - retaining ring; 7 - pusher. Clutch Master...

Clutch slave cylinder — removal, installation and repair
Models before 2000. Clutch slave cylinder components 1 - nipple; 2 - valve; 3 - spring; 4 - body; 5 - bleed screw; 6 - spring; 7 - piston assembly; 8 - anther; 9 -...

Clutch hydraulic hose and tubes — removal and installation
Removal Remove the master cylinder reservoir cap and pump out the fluid from it. Alternatively, open the bleed screw on the slave cylinder and gently press the clutch...

Diagnosing Clutch Faults

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

We recommend other sections on the topic of Hyundai manuals:

Transmission: Clutch Hyundai Accent 2 (1999-2005)
Transmission: Clutch Hyundai Getz (2002-2011)
Transmission: Clutch Hyundai Sonata 4 (2001-2012, petrol)
Transmission: Clutch Hyundai Tucson 2 (2009-2015)
Transmission: Clutch Hyundai Matrix (2001-2010, petrol)

Add to social network:

Link in different formats to this section

TextHTMLBB Code

Elantra 3 (2000-2006)