Diagnostics and testing — manual control cable Make sure the manual control cable is adjusted correctly by checking that the lock switch operates properly. 1. Apply the parking and service brakes securely. 2. Set the...
Diagnostic Trouble Codes 1. Connect a voltmeter or HI-SCAN scan tool to the diagnostic connector. 2. Clear diagnostic trouble codes. Then make the corrections according to the section "...
Description of diagnostic trouble codes Code Diagnostic trouble code (for voltmeter) Cause Method of elimination 11 Short circuit in the throttle position sensor circuit Check the throttle position sensor...
Checking oil pressure 1. Warm up the automatic transmission. 2. Raise the front of the vehicle so that the front wheels can turn. 3. Attach the tachometer to the engine and position it so...
Testing the torque converter The test consists of determining the maximum engine speed with the throttle fully open and the shift lever positions "D" and "R". This test checks the operation of the...
Four-speed automatic transmission controls Name Designation Pulse generator A,B A Throttle position sensor of the injection system IN Oil temperature sensor WITH Vehicle speed sensor D Data transfer connector E...
Technical support Checking the fluid level in the gearbox See the relevant section at the beginning of this chapter. Checking the operation of the selector lever 1. Move the lever to each...
Gearbox control mechanism Tightening torque: Nm Removal 1. Remove the remote control housing. 2. Remove the head mounting screws. 3. Disconnect the overdrive switch connector, remove the 3...
Automatic transmission — removal and installation Nm Kgf.cm Pound foot Outer diameter x Length, mm Bolt designation A 60-80 600-800 43-58 12 x 40 (1.6) AhV IN 43-55 430-550 31-40 10 x 70 (2.7) WITH 27-34 270-340 20-25...
Automatic transmission gearbox — disassembly Warning: Since the gearbox consists of high-precision manufactured parts, these parts must be handled with extreme care during disassembly and assembly to avoid damage....
Automatic transmission gearbox — assembly The assembly of the automatic transmission gearbox is carried out in the reverse order of disassembly using special tools. Warning: Do not reuse gaskets, seals or rubber...
Differential — disassembly and assembly Disassembly 1. Loosen the drive gear mounting bolts and remove it from the differential housing. 2. Using a special tool (09433-21000), remove the bearing. 3. Using a...
Valve body Components 1. Pressure reducing valve; 2. Spring; 3. Torque converter control valve; 4. Torque converter control valve spring; 5. Regulating valve; 6. Adjusting valve...