Car maintenance Hyundai Elantra 2

Vehicle Identification Number
The vehicle identification number (VIN) is located at the top of the bulkhead under the hood. 1. International Vehicle Manufacturer Identification Code; KMN - Hyundai...

Recommended lubricants and their consumption
Recommended lubricants Oil, liquid Technical specifications Notes Motor oil SG/CD or higher See SAE viscosity Manual transmission According to API classification: GL-4...

Checking the engine oil level
1. Place the vehicle on a level, horizontal surface. 2. Warm up the engine. Note: If the vehicle is not being serviced for a long time, warm up the engine for...

Engine oil change
1. Warm up the engine. 2. With the engine stopped, unscrew the drain plug and drain the oil. 3. Replace the drain plug and tighten. Tightening torque Drain plug - 35-45...

Replacing the engine oil filter
1. Replace the filter at every oil change. 2. Use a filter wrench to remove. 3. Drain the oil from the filter. 4. Lubricate the sealing ring of the new filter with a...

Checking and adjusting belt tension
Measure the belt deflection at the point shown in the figure. Belt deflection (with a load of 10 kg) Engine 1.6 l/1.8 l — 9.0-10.4 mm

Replacing the air filter
The air filter becomes dirty during operation, which reduces fuel efficiency. Replace the filter with a new one. 1. Remove the air intake hoses and pipe. 2. Disconnect...

Cooling system
Check the cooling system for damaged hoses, loose connections, and leaks. Antifreeze The engine cooling system uses a mixture of 50% ethylene glycol antifreeze and 50%...

Replacing ignition wires
Ignition wires should be replaced with new ones periodically. After replacement, check that the spark plug wires and clamps are properly connected and placed in the...

Oxygen sensor replacement
The heated oxygen sensor is a device that controls the composition of the fuel mixture. If the sensor is faulty, exhaust gas cleaning and engine responsiveness will be...

Spark plugs
1. Spark plugs must operate normally between scheduled maintenance intervals or they should be replaced. 2. On new spark plugs the gap between the electrodes must be...

Positive Crankcase Ventilation System (PCV valve)
The crankcase ventilation system must maintain efficient engine operation. Periodic maintenance is required to remove combustion products from the PCV valve. 1....

Fuel vapor removal system
1. If the vaporized fuel vent line is clogged or damaged, vaporized fuel will be released into the atmosphere, thereby increasing the harmful emissions from the vehicle....

Fuel system
Fuel tank, lines and connections 1. Check fuel supply lines and connections for damage or leaks. 2. Check the surface of the fuel hoses for damage caused by heat and...

Manual transmission
Checking the oil level Check for oil and oil leaks by removing the filler plug. If the oil is contaminated, it should be replaced with fresh oil. With the vehicle on a...

Drive axle in block with automatic transmission
Changing the fluid Drain the fluid if there are any signs of contamination. Once the cause of contamination has been eliminated, fill with new fluid. 1. Remove the drain...

Checking the steering gear drive
1. Check the steering wheel play Maximum clearance - 30 mm 2. Check the steering linkage for looseness and damage in the following order. 1) The ends of the transverse...

Power steering pump belt
Checking and maintenance 1. Check the belt for cracks and cuts. Replace the belt if necessary. 2. Check the belt tension. If necessary, adjust its tension as indicated...

Checking brake lines
1. Check for damage, wear, cracks, corrosion, leaks, kinks and twists in brake line hoses and pipes. 2. Check the tightness of all clamps. 3. Make sure that all lines...

Replacing brake fluid
1. See the relevant section below is the procedure for bleeding the brake system. 2. Attach a vinyl tube to the bleed screw on each wheel cylinder. Place the other end...

Checking the air pressure in the tires
Tire size Front Rear 175/65 R14 200 kPa 200 kPa 195/60 R14 Checked on cold tires

Road tests
While driving your vehicle, perform the following checks. 1. Check for oil, fluid, fuel, water and exhaust leaks. 2. Check the free play of the clutch pedal and brake...

Checking the brake fluid level
1. Visually check the fluid level in the master brake cylinder reservoir. 2. The fluid level should be between the "MIN" and "MAX" marks. 3. If the fluid level is below...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

We recommend other sections on the topic of Hyundai manuals:

General information: Maintenance Hyundai Accent 3 (2005-2010)
User manual: Maintenance Hyundai Getz (2002-2011)
General information: Maintenance Hyundai Sonata 3 (1993-1998)
Engine 2.7 liter: Engine maintenance Hyundai Santa Fe 2 (2007-2012, petrol)
General information: Maintenance Hyundai Tucson 1 (2005-2010)
Power unit: Engine maintenance Hyundai Matrix (2001-2010, petrol)

Add to social network:

Link in different formats to this section

TextHTMLBB Code

Elantra 3 (2000-2006)