Routine engine maintenance Hyundai Matrix

Checking the engine oil level
Place the vehicle on a level, horizontal surface. Warm up the engine. Note: If the car has been parked for a long time, warm up the engine for approximately 20 minutes....

Engine oil change
Caution! On vehicles equipped with engines with a catalytic converter, it is necessary to ensure that the oil level on the dipstick is not above the maximum mark. If too...

Selecting an oil filter
All Hyundai engines are equipped with a high-quality disposable oil filter. This type of filter is recommended as a replacement for all vehicles. However, the quality of...

Replacing the oil filter
Caution: Be careful not to burn yourself, as the engine oil is hot. Using a special key, remove the engine oil filter. Fig. 2.4. Applying engine oil to the filter gasket...

Checking the tightness of the cooling system
Remove the radiator cap. Make sure the coolant level reaches the radiator filler neck. Fig. 2.5. Connecting the tester to check the radiator cap valve Connect the...

Checking the radiator cap valves
Fig. 2.6. Special adapter for connecting the radiator cap to the tester Use a special adapter to connect the radiator cap to the tester (Fig. 2.6). Increase the pressure...

Checking the concentration of antifreeze
Fig. 2.7. Measuring the specific gravity of coolant using a hydrometer Measure the specific gravity of the coolant using a hydrometer (Fig. 2.7). Measure the coolant...

Compression check
Before measuring the compression, check the level and condition of the engine oil. Also, make sure that the condition of the starter and battery is normal. Start the...

Adjusting the timing belt tension
Raise the vehicle using a trolley jack. Slowly turn the steering wheel first clockwise, then counterclockwise. Note: There should not be any significant resistance to...

Drive of mounted units
Inspection and testing of the drive Visually inspect for obvious signs of mechanical damage. Up to 15 cracks per belt rib at a distance of 100 mm are allowed. If cracks...

Attachment drive belt tensioner
Static check The accessory drive belt tensioner can be checked statically by proceeding as described below. 1. Disconnect the accessory drive belt in the belt tensioner...

Adjusting the drive belt of attachments
Fig. 2.15. Correct seating of the belt in the pulley grooves Check that the belt is correctly seated in the pulley grooves (Fig. 2.15). Apply a force of 100 N to the...

Adjusting the alternator drive belt
Caution! Loosening the belt tension will result in a slipping sound and rapid belt wear. Caution! If the belt is too tight, there is a risk of damage to the coolant pump...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

We recommend other sections on the topic of Hyundai manuals:

General information: Maintenance Hyundai Accent 1 (1994-1999)
User manual: Maintenance and care Hyundai Elantra 3 (2000-2006)
User manual: Maintenance Hyundai Getz (2002-2011)
General information: Maintenance Hyundai Sonata 3 (1993-1998)
User manual: Maintenance and care Hyundai Santa Fe 2 (2007-2012, petrol)
General information: Maintenance Hyundai Tucson 2 (2009-2015)

Add to social network:

Link in different formats to this section

TextHTMLBB Code