Car engine specifications Hyundai Matrix

Table 2.1. Relationship between coolant density and ethylene glycol concentration
Temperature (°C) and specific gravity (g/cm³) of coolant Freezing point (C) Safe operating temperature (°C) Antifreeze concentration (% by volume) 10 20 30 40 50 1,054...

Table 2.2. Nominal adjustment data for drive belts of attachment units
Name When checking When adjusting For a new belt For used belt For generator drive Sag, mm Tension, N 5,1-6,0 4,0-4,4 5,1-5,7 350- 500 650-750 400-500 For air...

Table 2.3. Technical characteristics of the 1.6 l engine
Technical characteristics of the 1.6L engine

Table 2.4. Tightening torques for threaded connections of a 1.6 L engine
Component Tightening torque, Nm Cylinder Block Bolt and Nut for Fastening the Side Engine Support Bracket 45-55; 45-55 Oil pressure switch sensor 13-15 Cylinder head...

Table 2.5. Search for causes of malfunction and methods of their elimination
Possible causes of malfunction Method of elimination Low compression Cylinder head gasket burnout Replace the gasket Worn or damaged piston rings Replace the rings...

Table 2.6. Search for causes of hydraulic compensator malfunction and methods of their elimination
Search for causes of hydraulic compensator failure and methods of their elimination

Table 2.7. Piston ring repair size and identification mark
Piston ring repair size and identification mark Nominal size No tag 0.25 mm 25 0.50 mm 50 0.75 mm 75 1.00 mm 100

Table 2.8. Technical characteristics of the 1.8 l engine
Technical characteristics of the 1.8L engine

Table 2.9. Tightening torques for threaded connections of a 1.8 L engine
Component Tightening torque, Nm Cylinder Block Bolt and Nut for Fastening the Side Engine Support Bracket 35-50 Front Engine Mount Bracket Bolt 70-90 Rear Engine Mount...

Table 2.10. Search for causes of malfunction and methods of their elimination
Finding the causes of the malfunction and ways to eliminate them

Table 2.11. Nominal adjustment data for drive belts of attachment units
Name When checking When adjusting For a new belt For used belt For generator drive Sag (mm) Tension (N) 5,1-6,0 4,0-4,4 5,1-5,7 350-500 650-750 400-500 For air...

Table 2.12. Piston ring repair size and identification mark
Piston ring repair size and identification mark Nominal size No tag 0.25 mm 25 0.50 mm 50 0.75 mm 75 1.00 mm 100

Table 2.13. Repair dimensions of holes for valve seats
Repair dimensions of holes for valve seats Description Repair size, mm Identification tag Saddle height (H), mm Cylinder head opening diameter for valve seat, mm Intake...

Table 2.14. Repair dimensions of valve guide bushings
Repair dimensions of valve guide bushings Repair size, mm Identification tag Diameter of cylinder head opening for valve guide bushing, mm 0,05 5 11,05-11,068 0,25 25...

Table 2.15. Technical characteristics of the control system
Technical characteristics of the control system

Table 2.16. Data for verification
Name Engine Meaning Terms and Conditions Crankshaft speed at idle, min⁻¹ 1.6 l 800±100 With the air conditioner on or off (with the gearshift lever in neutral or the...

Table 2.17. Tightening torques for threaded connections
Tightening torques for threaded connections Name Nm kgf cm Fuel rail mounting bolts 10-15 100-150 Heated oxygen sensor 50-60 500-500 Crankshaft Position Sensor Mounting...

Table 2.18. Sealants used
Sealants used Coolant temperature sensor LOCTITE 962T or equivalent Coolant Temperature Gauge Sensor Three bond No.2310 or equivalent

Table 2.19. Troubleshooting the Fuel Supply System
Troubleshooting the Fuel Supply System

Table 2.20. Troubleshooting the Fuel Supply System
Troubleshooting the Fuel Supply System Possible causes of malfunction Method of elimination After the pressure stops, the fuel pressure slowly decreases Leaks through...

Table 2.21. When the engine is cold
When the engine is cold Engine operating mode Created vacuum In good condition Idling 50 kPa The vacuum remains 3000 min⁻¹

Table 2.22. When the engine is cold
When the engine is cold Engine operating mode Created vacuum In good condition Idling 50 kPa The vacuum remains Within approximately 3 minutes after the engine reaches...

Table 2.23. Diagnostic trouble codes (1.6 l, 1.8 l with European on-board diagnostics)
Code No Description of malfunctions Memory Kln P0030 Oxygen Sensor Heater Supply Voltage Incorrect (Bank 1 Sensor 1) 0 0 P0031 Oxygen Sensor Heater Element Circuit Low...

Table 2.24. Diagnostic trouble codes (1.6 l, 1.8 l without European on-board diagnostics)
Code No Description of malfunctions Memory Kln P0031 Oxygen Sensor Heater Element Circuit Low (Bank 1 Sensor 1) 0 X P0032 Oxygen Sensor Heater Circuit High (Cylinder 1...

Table 2.25. Checking with a tester
The element or parameter to be checked Output data Verification conditions Air conditioner switch position Normal indication Air conditioner switch Switch status...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

We recommend other sections on the topic of Hyundai manuals:

User manual: Vehicle Specifications Hyundai Santa Fe 2 (2007-2012, petrol)

Add to social network:

Link in different formats to this section

TextHTMLBB Code