Automatic transmission cars Hyundai Elantra 1

General description of automatic transmission
The cars may be equipped with an automatic transmission. The automatic transmission has four forward gear ranges that shift automatically. To assess the condition of an...

Automatic transmission — removal and installation
Drain the oil from the gearbox. Remove the lower protective cover, air filter, battery and its bracket. After unscrewing the nut, disconnect the cable connecting the...

Checking the working fluid (oil) level
For normal operation of the automatic transmission, it is very important to maintain the prescribed oil level. Therefore, the check should be carried out exactly after...

Oil filter — replacement
It is recommended to replace the filter and flush the transmission pan together with the fluid change.

Gearbox fluid replacement
The fluid is usually replaced every 60 thousand km. Raise the front of the vehicle. Unscrew the drain plug and drain the liquid. Screw the drain plug back into place....

Checking the operation of the automatic transmission
Abnormal operation of the gearbox may be caused by the following reasons: poor quality adjustment; faults in hydraulic or mechanical systems; malfunctions in the...

Starter Lock Mechanism — Check
Late models of the car If the conditions described below are not met, adjust the ignition lock cable. If the brake pedal is fully depressed and the ignition key is in...

Mode Switch Lock Mechanism — Check
Late models of the car If the conditions described below are not met, adjust the transmission mode lock cable. If the brake pedal is fully depressed and the ignition key...

Selector switch and control cable — adjustment
Set the selector lever to position N. Loosen the adjusting nuts (arrows) securing the cable to the control lever and disconnect the cable. Set the manual control lever...

Kickdown forced downshift mechanism — adjustment
Clean the area around the mechanism and the mechanism itself. After removing the retaining ring, remove the kickdown switch. Using the tools, loosen the lock nut....

Working fluid pressure — adjustment
Drain the working fluid from the gearbox. Remove the oil pan, filter and working fluid temperature sensor. Remove the valve body assembly. Location of electromagnetic...

Trouble codes — reading
The fault codes are read from the automatic transmission diagnostic connector using special diagnostic equipment Caution: When the battery is disconnected, all stored...

Torque converter — testing on a fully braked vehicle
The test is carried out to determine the maximum rotation frequency of the engine crankshaft with the output shaft of the gearbox completely stopped in the D and R...

Selector lever — check
Check the ease and smoothness of movement of the selector lever and its fixation in each position. Check the readings on the selector lever position indicator, which...

Automatic Transmission Controls — Removal and Installation
Automatic transmission controls (early models) 1 - control cable; 2 - solenoid locking unit; 3 - control lever; 4 - lever body; 5 - cable for switching on the reverse...

Towing cars with automatic transmission
When towing the vehicle, the gearshift lever must be in position N. Maximum towing speed: 50 km/h. Maximum towing range: 50 km. If you need to tow over long distances,...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

We recommend other sections on the topic of Hyundai manuals:

Transmission: Automatic gearbox Hyundai Accent 2 (1999-2005)
Transmission: Automatic gearbox Hyundai Getz (2002-2011)
Transmission: Automatic gearbox Hyundai Sonata 4 (2001-2012, petrol)
Transmission: Automatic gearbox Hyundai Santa Fe 2 (2007-2012, petrol)
Transmission: Automatic gearbox Hyundai Tucson 2 (2009-2015)
Transmission: Automatic gearbox Hyundai Matrix (2001-2010, petrol)

Add to social network:

Link in different formats to this section

TextHTMLBB Code

Elantra 3 (2000-2006)