Release bearing mounting elements (models before 2000.)
1 - gearbox housing;
2 - clutch slave cylinder;
3 - leading clutch disc;
4 - driven disk;
5 - spring;
6 - release bearing;
7 - clutch release fork;
8 - rotary pin;
9 - anther.
Release bearing mounting elements (models since 2000.)
1 - release bearing;
2 - nut;
3 - lever;
4 - clutch release fork;
5 - leading clutch disc (basket);
6 - driven clutch disc.
Removal
Remove the gearbox.
Press down the retaining spring and remove the release bearing.
(The publication is borrowed from the website: HYUNDAIBOOK.ru)
Examination
Squeeze and turn the release bearing at the same time. If the bearing does not turn straight, it should be replaced. The bearing is lubricated for long term use and should not be cleaned or lubricated.
The bearing should also be replaced if there is significant wear at the points of contact with the release fork.
Installation
Place special molybdenum grease (arrows) into the groove under the release bearing.
Apply grease to the contact surfaces of the release fork.
Insert and secure the release bearing with the retaining spring.
Install the gearbox.