Contents: Removal ⇓ Installation ⇓
Removal
Remove the cross beam.
Loosen the bolts and disconnect the strut from the anti-roll bar.
Loosen the bolt and remove the bracket (2) securing the stabilizer bushing (1).
Remove the bushing from the stabilizer.
Remove the anti-roll bar.
Stabilizer mounting elements (models produced before 2002)
1 - stabilizer link;
2 - anti-roll bar;
3 - bushing;
4 - ball joint.
Stabilizer mounting elements (models from 2002)
1 - stabilizer link;
2 - stabilizer;
3 - bushing;
4 - clamp.
Installation
Installation is carried out in reverse order, taking into account the following:
The stabilizer is installed so that the mark (1) is on the right side. Then install the bushing so that the mark is positioned as shown in the figure on the next page).
Models produced before 2002
Models since 2002
Install the cross beam.