Models with internal gear pump (2.0L engines)
Oil pump mounting elements for 2.0 liter engines
1 - cylinder block;
2 - oil pan;
3 - oil receiver;
4 - oil filter;
5 - oil pump.
Removal
Disconnect the ground cable from the battery.
The article is copied from this website hyundaibook
Raise the car on a lift.
Drain the engine oil.
Unload the engine mounts and remove the front bracket and V-belts.
Remove the engine camshaft drive components.
Remove the oil pan.
Remove the front engine cover with the oil pump.
Installation
The oil pump is installed in the reverse order.
Models with external gear pump (1.6L and 1.8L engines)
Oil pump components for 1.6 and 1.8 liter engines
1 - oil pump cover;
2 - driven gear;
3 - leading gear;
4 - Front engine cover;
5 - oil seal;
6 - ring;
7 - cork;
8 - pressure reducing valve plug;
9 - gasket;
10 - spring;
11 - plunger (piston);
12 - Oil filter bracket;
13 - oil pressure sensor;
14 - oil filter;
15 - oil seal;
16 - gasket;
17 - cover.
Removal
Disconnect the ground cable from the battery.
Raise the car on a lift.
Drain the engine oil and coolant.
Unload the engine mounts and remove the front bracket and V-belts. •Remove the engine camshaft drive components (with belt).
After unscrewing the oil filter, remove the filter bracket.
Remove the oil pan.
After unscrewing the plug in the front cover, secure the baffle shaft with a screwdriver to prevent it from turning. Loosen the pump driven gear bolt.
Mark the position of the gears (A) and remove.
Installation
The oil pump is installed in the reverse order.