2. Using the 09411-11000 tool, install the driven disk onto the flywheel.
3. Install the clutch housing on the flywheel and tighten the six (6) mounting bolts crosswise to a torque of 15-22 Nm. Tighten the bolts alternately by one or two turns each time to prevent warping of the clutch housing flange.
4. Remove the mandrel for centering the driven disk.
5. Install the release bearing (A) and align it with the clutch release fork (B).
6. Install the clutch release fork shaft lever.
5. Install the gearbox (see chapter "Transmission").
6. Check the clutch release fork lever travel angle. If the angle exceeds 3°, the assembly is not correct.
