Acceleration Sensor (APS) (Hyundai Getz 1)

The acceleration sensor is used to roughly determine road conditions. The sensor signal is used by the engine control unit to detect abnormal misfires.

Examination

Use a voltmeter to check the output voltage of the acceleration sensor.

Output voltage:

at idle: 2.3–2.7 V
ignition off: 0 V

The article is copied from this website (HYUNDAIBOOK.ru)

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This article has been reviewed by: Konstantin Smirnov

Add to social network:

Getz: Fuel system

Ignition coil
Engine Management System Power Main Relay
Fuel Evaporative Control System Solenoid Valve (PCSV)
Air Conditioner Switch and Relay
Knock Sensor (KS)

Fuel line and injectors — removal and installation
Throttle assembly — removal and inspection
Fuel tank — removal and inspection
Accelerator pedal and cable — removal and installation

We recommend other articles on the topic of Hyundai manuals:

Oil pressure sensor Hyundai Accent 1 (1994-1999)
APS acceleration sensor Hyundai Elantra 3 (2000-2006)
Replacing the oxygen sensor Hyundai Sonata 3 (1993-1998)
Removal and installation the coolant temperature sensor Hyundai Santa Fe 2 (2007-2012, petrol)
Longitudinal acceleration sensor Hyundai Tucson 2 (2009-2015)
Coolant temperature sensor Hyundai Matrix (2001-2010, petrol)

Link in different formats to this article

TextHTMLBB Code

Visitor comments

No comments yet