1. Remove shift and select cable bracket.
2. Remove the rear cover bolt and the cover itself.
3. Remove the switch of a lantern of a back light, a lining and an arm.
4. Remove the seal bolts, springs and mounting bracket.
Warning. Don't lose the springs or balls.
5. With a special tool (09414-11000) remove the spring pin.
6. Remove locknuts.
7. Use the shift lever and select lever to engage first gear.
8. Move the 5th gear synchronizer to the 5th gear, loosen and remove the jam nuts.
9. Remove the 5th gear synchronizer cage and shift fork.
10. Remove the 5th gear synchronizer hub, 5th gear gear and needle roller bearing using the special tool (09455-21000).
11. Remove the 5th idle gear with the special tool (09455-21000).
12. Remove the fifth gear bushing, then remove the circlip.
13. Remove the reverse gear axle bolt.
14. Remove the transmission housing set bolt in the clutch housing, then remove the transmission housing.
15. Remove oil guides.
16. Remove the output shaft bearing outer race and spacer using the special tool (09455-23000).
17. Remove the reverse lever.
18. Remove the reverse gear shaft and reverse gear.
19. With a special tool (09414-11000) remove the spring pins.
20. Disconnect the shift rod and yoke assembly.
21. Remove the bearing cage.
22. Remove the drive and output shafts at the same time.
23. Remove the differential assembly.
24. Remove the speedometer driven gear assembly.
25. Using a special tool (09455-32200) remove the outer race of the output shaft bearing.
26. Using the special tool, remove the input shaft oil seal.
27. Remove the output shaft oil guide.
28. Remove the input shaft oil seal.
29. Remove the control shaft assembly.