Removal
1. Remove the console assembly.
2. Remove the cotter pins and clamps (from the gear shift lever side).
3. Remove the gear shift lever assembly.
4. Remove the holder and bolts.
5. Remove the cotter pins and clamps (from the gearbox side).
6. Remove the shift and select cables.
Examination
1. Check the functionality of the selector cable and the presence of damage.
The material was obtained from a web resource [HYUNDAIBOOK.RU]
2. Check the shift cable for functionality and damage.
3. Check the cable sheaths for damage.
4. Check each bushing for wear, binding or damage.
5. Check for loose or damaged springs.
Installation
1. Install the gear shift lever assembly.
2. Installing the gear shift lever and selector cable.
- 1) Move the gear selector and shift levers to neutral position.
- 2) When connecting the selector cable to the lever (B), adjust the length of this cable so that the lever (B) is in the neutral position.
- 3) The side of the rubber bushing with the edge at the end of the selection cable should be positioned on the surface of the lever (B).
- 4) The edged side of the rubber bushing at the end of the shift cable should be positioned against the hole for the cotter pin in the shift lever.
- 5) After connecting the shift cable, check that the dimensions (A) and (B) shown in the figure are the same.
- 6) Move the gear shift lever to each position, making sure that the gear shifts smoothly.
3. Install the holder and bolts.