Bleeding the clutch hydraulic drive (Hyundai Accent X3)

In each case, after removing the hydraulic lines or the clutch master cylinder, or if the clutch pedal fails, bleed the clutch hydraulic system.

Warning: Use fluid specified in SAE J1703 (DOT 3).

1. Loosen the bleed screw on the clutch slave cylinder.

2. Slowly press the clutch pedal until air is no longer supplied.

3. Keep the pedal depressed while tightening the bleed screw.

4. Top up the master cylinder with the fluid specified in the specification.

Warning. When bleeding the clutch hydraulic drive, repeatedly pressing the clutch pedal in the B-C zone (see figure) may cause the piston to be pushed out of the slave cylinder housing. Press the clutch pedal again only after it has fully returned to position A.