Note: Do not disassemble the valve. It regulates the distribution of fluid under pressure between the front and rear brakes to prevent slippage in the event of wheel lockup and improves braking efficiency.
1. Connect two pressure gauges to the valve: one on the inlet side and one on the outlet side.
Note: After connecting the pressure gauges, it is necessary to remove air from the system.
2. With the brakes applied, measure the inlet and outlet pressure. If the results are within the acceptable range, the valve is working properly.
3. Connect the brake hoses and valve.
4. Tighten the nuts and remove air from the system.
- Tightening torque of brake hose nuts: 13-17 Nm
- Valve nuts - 8-12 Nm