Removal
1. Remove the lower bolt and lift and move the caliper to the side. Secure the caliper in this position with wire.
2. Remove the pads.
Warning: Do not press the brake pedal while removing the pads.
Examination
1. Check the linings for wear, and also make sure that no oil has gotten on them. Replace if necessary.
Warning: When replacing, replace all the pads on both the right and left wheels. Never "break" the set.
Overlay thickness:
- Standard value is 9.0 mm
- Maximum allowable - 1.0 mm
2. Check the gaskets for damage or deformation.
Installation
1. Install the pad clamps.
2. Install the covers.
Note: When installing the pads, make sure that the wear indicators are facing the disc and up.
3. Using a special tool (09581-11000) install the piston into the cylinder.
4. Install new pads. The pads are attached to the pads as shown in the figure.
Warning: Never apply grease to the disc or pads.
The original text is available on the website www.hyundaibook.ru
5. Install the bolt and tighten it to the specified torque.
- Tightening torque - 22-31 Nm